Chicco Crescendo Lite Manual De Instrucciones página 12

9. Secure the baby with the safety harnesses, using the sliders
to adjust the length of the harnesses so they fit the child.
If used as highchair, it is possible to:
- Adjust the footrests;
- Use the tray.
To perform the above mentioned operations, refer to the corre-
sponding paragraphs.
POSITIONING THE TRAY (FOR THE CRESCENDO UP)
10. To fasten the tray "D", insert it into the sides of the chair until
the end position is reached, being to sure to confirm proper
attachment (Fig. 10A-10B).
WARNING: To avoid crushing, ensure that the child's hands
are far from interlocking components while the tray is being
attached to the seat.
Before use, always check that the tray has been properly fas-
tened to the chair.
WARNING: Do not subject the tray to a load of more than 2 kg.
11. To remove the tray, act on the tabs provided, moving them
outwards while pulling the tray free (Fig. 11).
FOOTREST
The highchair is equipped with an upper footrest "A6" that can
be adjusted to 2 different heights.
12. To change the position of the upper footrest, move it and
connect it to the appropriate sites "A8" using the Allen
wrench "E" provided. When carrying out this step, make sure
that the footrest is facing the right direction as indicated in
Figure 12.
WARNING: Check that the footrest screws have been tight-
ened properly before use.
WARNING: The lower footrest "A7" must not be removed in the
highchair configuration.
CLOSURE
WARNING: The child must never be seated in the product
when this operation is carried out. When performing this op-
eration, ensure that your child, or other children, are at a safe
distance.
13. Disconnect the chair by pressing button "A3" and rotating
the chair anticlockwise (Fig. 13). Lift the chair to remove it
completely from the seat area "A1".
14. Continue closing the seat area by rotating the lever "A5" and
pressing button "A4" as described in point 2. Then fold the
rear legs onto the front legs (Fig. 14).
WARNING: When in the closed position, the product does not
stand up on its own. Lean the product against a surface.
BABY CHAIR CONFIGURATION (36m+)
The product can be used as a baby chair from 36 months of age
and up to a maximum weight of 40 kg.
WARNING:
• DO NOT place this product near a
window where cords from blinds
or curtains may strangle a child.
• DO NOT place this product near
a window, as the child may climb
onto the product and fall out the
window.
• Be aware of the risk of open fire and
other sources of strong heat in the
vicinity of the product.
• Age range intended for use: from 36
months up to a maximum weight
of 40 kg.
• Do not use the product if any part is
broken, torn or missing.
• Do not use components, replace-
ment parts or accessories that have
not been supplied or approved by
the manufacturer.
• Before use, check that all the com-
ponents of the chair have been as-
sembled correctly.
WARNING: In the baby chair configuration (Fig. 15), the lower
footrest "A7" must always be present and used.
The position of the upper footrest "A6" can be adjusted to suit
the height of the child by using the sites "A8" as indicated in the
"FOOTRESTS" paragraph.
WARNING! After adjusting the position of the footrest, check
that the footrest screws have been tightened properly before
use.
WARNING: Check that the frame has been fastened properly
as described in point 3.
WARNING: Check that the seat cover is present and has been
fastened properly. To fasten the seat cover, insert it into the
appropriate section and rotate clockwise until a click is heard
(Fig. 16).
ADULT CHAIR CONFIGURATION (max 110 kg)
The product can be used as an adult chair by people who
weigh no more than 110 kg
WARNING:
• Use permitted: up to a maximum
weight of 110 kg.
• Do not use this product if any part
is broken, torn or missing.
• Do not use components, replace-
ment parts or accessories that have
not been supplied or approved by
the manufacturer.
WARNING: In the adult chair configuration (Fig. 17), the lower
footrest "A7" must always be present and used.
The upper footrest "A6" may be removed in this configuration.
ADDITIONAL FEET (FOR THE CRESCENDO UP)
In the CRESCENDO UP version, the 3 configurations (highchair,
baby chair, adult chair) can also be used in the high configura-
tion, replacing the feet on the product.
15. Remove the feet "A9" and "A10" by pressing on each foot but-
ton and pulling the foot free (Fig. 18).
12