Cleaning And Maintenance - Tribest Shine Kitchen SJV-107 Manual De Funcionamiento

1. Clean the following parts with soap and running water. These parts may be soaked
for easier cleaning. Use both ends of the Brush to thoroughly clean and remove any
left over pulp.
Auger Sealing Ring*
Housing
See below for
more instructions.
2. Use a damp cloth or sponge to clean the Main Body. Do not submerge or use
running water to clean the Main Body.
Sealing Ring illustrated
from bottom of the
Auger Housing

7. CLEANING AND MAINTENANCE

Auger Feeding Chute
Sealing Ring*
1. Disassembly: Locate the circular, silicone sealing
ring from the bottom of the Auger Housing and
push its outer edge toward the center until it
comes off completely.
2. Assembly: After it is thoroughly dried, put the
sealing ring properly back in its place. Compress
the sealing ring from two sides and slide it into
the center portion of the Auger Housing with the
larger side facing up. Adjust the ring until it is
fitted above and below the plastic ridge. Once
properly in place, the sealing ring should be
secure.
Pusher Pressure
Plug
Slicer
EN
11