Publicidad
Idiomas disponibles
Idiomas disponibles
4
With the top rail (F)frame connected into
a circle, lay it flat on the floor(either side
facing up—they are identical). Then
insert the tapered end of each of the 6
leg tubes(K)into the 6 leg sockets that
are facing up, as shown. The Curves
should all point out—away from the
center of the trampoline.
Assembly Instructions
(Jumping Mat)
NOTE:
CHOKING HAZARD
-Small Parts. Not for children under 3 years.
ADULT ASSEMBLY REQUIRED
-Contains small parts, sharp points and sharp edges.
1
Lay out the jumping mat (B) in the center
of the frame. Then slide a suspension cord
(C) from left to right through the sewn-in
loop as shown.
06
5
Align the screw hole in the leg tube (k)
with the hole in the leg socket. Then
secure with screw and tighten. DO NOT
OVER-TIGHTEN. Repeat this until all 6
legs are securely attached to the top rail
(F) frame with screws (D).
2
Use your right hand to stretch the
loop end of the cord (C) OVER the
top rail (F) and your left hand to pull
the ball end of the cord (C) UNDER
the top rail (F), then press the ball
through the loop.
4
From the 1st attached cord, count around the jumping mat to the 16th loop. Like the
picture show position 1&2. Then repeat step 1 to step 3 to fix the position 3,4,5,6.
Finally fix all the suspension cords (C) evenly. By doing so, it will ensure even-tension
around the entire jumping mat (B).
EN
3
SLOWLY release the loop end of the
cord so that it captures the knob,
locking the suspension cord (C) in
place, as shown.
07
Publicidad
