LEGRAND LEXIC 047 71 Manual página 5

Time switch
D22 - 2 Channel
047 71 / 604 770 / 604 772
Channel display
Function
Receptacle for
data key
+
1800W 1800W 1800W 2300W
Overview
Technical data
Supply voltage: 230V 50/60Hz
Consumption : ca. 1 W
Contact rating: 2 changeover contact 16A 250V~µ cos ϕ = 1
Parallel compensation 60VA max. 7µF
Accuracy : ± 0,2 s /day under typical installation conditions
single strand
Terminal capacity: 1,5...4 mm
Programmes: 28 per channel
Battery reserve: 6 years
Storage ambient: -20°C to +60°C
Working ambient: -20°C to +55°C
Overview of programmed
switching times for the week.
Resolution 0.5h
Switch status of the current
channel
Day, Time, Date
+
100W 100W 1800W
047 71 604 770
120V 50/60Hz
2
Safety instructions
• This product may only be installed and assembled by suitably qualified
personnel. • Electrical safety is only guaranteed if the product is installed
in its product-specific installation environment complete with all supplied
accessories. • Any tampering with the product shall automatically nullify
any product liability claims. • Observe your national legislation and all
applicable safety provisions.
General information
• Start-up: after applying the supply voltage, the time switch
starts automatically with the last selected function. The relay
position is set by the current program.
• Battery backup
- Backlighting not active
- Data key READ/WRITE only via the menu.
• For saftety, when the time switch is connected to the mains
supply the contact should not be used on an isolated low volta-
ge supply and when the time switch is connected to the isolated
voltage supply the contact should not be used on the mains
supply.
Select menu, back to main menu,
MENU
Hold down > 1s = operating display
Confirm selection or load parameters
OK
2300W
C1 C2
³
604 772
24V AC/DC
multi strand
1,5...2,5 mm 2
Operating instruction
• Select menu options or set parameters
• Channel selection
Set language
GB
®