TREND CRT/MK3 Instrucciones Originales página 25

DESCRIPTION OF PARTS - (Fig. 1)
A. Legs
B. Insert plate
C. Table top
D. Back fence
E. Fence cheek
F. Top pressure
G. Top guard
H. Lead-on pin
I. Mitre fence
J. Switch
K. Pushstick
L. Insert rings
M. Table top scales
N. Side pressure
O. Dust spout
P. Bench mounting bracket
Q. Lead-on pin park
R. Spanner
S. Hex key 3mm AF
T. Edge planing rod
U. Edge planing rod locking assembly
V. Backfence scale
W. Cable management clips
X. Leg rails long
Y. Leg rails short
Z. Router fixing screw pack
ITEMS REQUIRED
• Phillips® No.2. screwdriver.
• Router.
• Hand tools.
• User made bench.
• Spanner 8mm A/F for mitre fence.
• Slotted screwdriver for lead on pin.
ASSEMBLY
Assembly of Table and Leg Frame
- (Fig. 2)
Leg Assembly - (Fig. 3)
Bench Top Assembly - (Fig. 4)
EN - CRT/MK3
Router Compatibility
Make
TREND
TREND
CMT
DEWALT
DEWALT
ELU
ELU
PERLES
Mounting Router to Insert Plate
- (Fig. 5)
Mounting Table to Workbench or
Workboard - (Fig. 6 & 6a)
The router table can be mounted onto a suitable
workbench or workboard. Ensure the legs of the table are
supported and do not overhang.
A recommended working height is 900mm from table top
to floor.
Mounting No Volt Release Switch
- (Fig. 7 & 7a)
The switch can be positioned at the front of the table or
on the right hand side.
CAUTION:
is comfortable and that the table is secured to
a work bench. Ensure workbench is stable and
secure.
Levelling the Insert Plate - (Fig. 8)
The insert plate can be levelled to the table top by
adjusting the seven set screws with the hex key.
Fitting Insert Rings - (Fig. 9, 9a & 9b)
WARNING:
are a tight fit in the insert plate. Replace damaged
or loose rings immediately.
- 25 -
Router Model Screw x Qty
T3, T4, T5 B X 2
T10, T11, T12, T14 B X 3
CMT1E B X 3
DW613, 614, 615 B X 2
DW624, 625E, DWE625, B X 3
627
MOF96)E) MK2 B X 2
MOF131, 177 (E) MK2 B X 3
OF808(E) > 1999 B X 2
Ensure working position
Always ensure insert rings