TREND CRT/MK3 Instrucciones Originales página 27

• Place component onto mitre fence.
• Plug into power supply.
• Feed right to left holding component securely.
• Switch off.
NOTICE:
The mitre fence has fixing holes
to allow a spelch block to be secured using screws
(not supplied).
Lead-on Pin
- (Fig. 24, 24a, 24b & 24c)
• Isolate from power supply.
• Fit lead-on pin into threaded hole using a slotted
screwdriver.
• Move back fence back.
• Fit self guided cutter.
• Fit top guard.
• Plug into power supply.
• Support component onto the lead-on pin and swing into
cutter and contact bearing guide.
• Mould component. n Switch off.
WARNING:
Ensure guard is fitted when using self guided
cutters.
NOTICE:
The lead-in pin can be stored in
the pin park hole in the back fence when not in use.
Edge Planing
- (Fig. 25, 25a, 26 & 26a)
• The rods can be parked in the T-slots in the top of the
back fence.
• The rods are held by tightening the knobs.
• After use of the table, keep assembled and store
properly.
ACCESSORIES
Please use only Trend original spare parts and
accessories.
Hose and Connector Ref. CRT/4
- (Fig. 27 & 27a)
The back fence is provided with an extraction point for
connection to suitable vacuum extractors. The internal
hole diameter is 57mm (2-1/4").
• Only a vacuum extractor unit recommended for use in
the workshop should be used.
Guard removed for clarity.
EN - CRT/MK3
MAINTENANCE
• The router table has been designed to operate over a
long period of time with a minimum of maintenance.
Continual satisfactory operation depends upon proper
tool care and regular cleaning.
• Replace the cutter insert when worn out.
Cleaning
• Keep the grooves clear of sawdust. Regularly clean the
table with a soft cloth.
• The pushstick is made of thermoplastic material which
is resistant to solvents, oils, greases and water. Do not
use concentrated acids or alkalies for cleaning.
Lubrication
• Your router table requires no additional lubrication. Do
not use PTFE spray on the plastic components of the
table.
Storage
• When not in use the table should be stored safely. It is
advisable to cover the table.
• The pushstick is provided with holes to store easily on
the table.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing as waste.
Accessories and packaging should be sorted for
environmental-friendly recycling.
Separate collection. This product must not be
disposed of with normal household waste.
Household User
Local regulations may provide for separate collection
of electrical products from the household, at municipal
waste sites or by retailer when you purchase a new
product. Please call Trend Customer Services for advice
as to how to dispose of unwanted Trend electrical
products in an environmentally safe way or visit
www.trend-uk.com
Business Users
Please call Trend Customer Services for disposal of
unwanted Trend electrical products.
WARRANTY
This unit carries a manufacturer's warranty in accordance
with the conditions on our website www.trend-uk.com
- 27 -