Behringer DIGITAL MULTI-FX FX600 Manual De Instrucciones página 2

2
DIGITAL MULTI-FX FX600
The ON/BATT LED illuminates when the effect is activated. It also
(5)
serves as a battery level indicator.
Use the footswitch to activate/deactivate the effect.
(6)
Use the two 1/4" TS connectors IN A and IN B to plug in a stereo
(7)
input signal. For mono use just plug in IN A.
The two 1/4" TS connectors OUT A and OUT B send the signal to
(8)
your amp. Use both connectors if you want to achieve full stereo
effect. For mono use just plug in OUT A.
Use the DC IN connection at the front of the unit to plug in a 9 V power
supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover.
To install or replace the 9 V battery, press the hinges with a ballpen and
remove the pedal cover. Be careful not to scratch the unit.
◊ ◊
The FX600 has no on/off switch. As soon as you insert the
jack into the in connector, the FX600 begins running.
When not using the FX600, remove the jack from the in
connector. This extends the life of the battery.
The SERIAL NUMBER is located at the bottom.
2. Safety Instructions
Do not use near water, or install near heat sources. Use only authorized
attachments/accessories. Do not service product yourself. Contact our
qualified servicing personnel for servicing or repairs, especially when
power supply cord or plug is damaged.
3. Warranty
Please register your new Behringer equipment right after your purchase
by visiting community.musictribe.com/pages/support#warranty and
read the terms and conditions of our warranty carefully.
4. Specifications
In A
Connector
Impedance
Impedance mono
In B
Connector
Impedance
Out A
Connector
Impedance
Out B
Connector
Impedance
1/4" TS
500 kΩ
250 kΩ
1/4" TS
500 kΩ
1/4" TS
1 kΩ
1/4" TS
1 kΩ