Publicidad
Step 3
Diagram 1. Measure 1-1/2" from one end of the INTERLOCK TRACK (26G). Position the INTERLOCK TRACK as shown.
å
SAFETY STOP / TRACK ATTACHMENT:
å
Diagram 2. Tilt the fi rst edge of the INTERLOCK TRACK (26G) into the SAFETY STOP (29G).
Diagram 3. Rotate the INTERLOCK TRACK and apply force to snap the second edge into the SAFETY STOP.
å
Diagram 4. Repeat the STOP / TRACK ATTACHMENT for the next SAFETY STOP while holding the previously completed
å
SAFETY STOP in its location hole. Repeat these steps until all SAFETY STOPS have been attached. Visually check that all
INTERLOCK TRACK edges have been snapped into the SAFETY STOPS as shown in diagram 3.
Diagram 5. Remove the INTERLOCK TRACK assembly from Diagram 4 and fl ip it over before inserting the INTERLOCK
å
TRACK (26G) with SAFETY STOPS (29G) into the groove in the RIGHT END (A).
Be sure the
interlock track
snaps into each
safety stop.
www.sauder.com/services
A
5.
A
The interlock system is a safety feature
that prevents more than one drawer
from opening at the same time. Do not
use excessive force to open the drawers.
4.
2.
417244
1.
26G
29G
Tape Measure
26G
3.
29G
Page 7
Publicidad
