Publicidad
Step 4
Separate the EXTENSION SLIDES (K) from the
å
EXTENSION RAILS (J) as shown in the upper diagram
below. Be prepared, the parts are greasy.
Fasten the EXTENSION RAILS (J) to the ENDS (A and B).
å
Use twelve GOLD 5/16" FLAT HEAD SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into
å
the hole shown in the enlarged diagram. Then, slide the
innercartridge of the EXTENSION RAIL out to fi nd the
other hole that lines up with the hole in the END. Turn a
SCREW into this hole.
Open end
Page 8
K
Push the black lever in and pull the SLIDE from the RAIL.
Edge with HIDDEN CAMS
J
J
B
J
J
After fastening the CABINET RAILS to the RIGHT END (A),
the SAFETY STOPS should touch the top edge of the RAILS.
If the gap is larger than 1/16" the drawers could lock up and
not open. If this happens, open two drawers at the same
time to override the interlock system. Remove the drawers
to re-adjust the INTERLOCK TRACK assembly.
417244
Remember:
Righty tighty.
Lefty loosey.
3S
GOLD 5/16" FLAT HEAD SCREW
(12 used in this step)
J
J
A
J
www.sauder.com/services
Open end
Publicidad
