Publicidad
Idiomas disponibles
Idiomas disponibles
Note:
The arrow on the tines must point
in the point the direction of forward rotation
(counterclockwise, when viewed from the left
side).
•
For a 40.6 cm (16 inch) tilling width, install
the outer tines with the short end of the tine
pipe facing toward the center of the machine.
Figure 12
1. Bolt and locknut (2)
•
For a 53.3 cm (21 inch) tilling width, install
the outer tines with the short end of the
tine pipe facing toward the outside of the
machine.
Figure 13
1. Bolt and locknut (2)
4.
Secure the outer tines using the 2 bolts and 2
locknuts.
During Operation
During Operation Safety
General Safety
•
Use your full attention while operating the
machine. Do not engage in any activity that
causes distractions; otherwise, injury or property
damage may occur.
•
Do not operate the machine while ill, tired, or
under the influence of alcohol or drugs.
•
Wear appropriate clothing, including eye
protection; long pants; substantial, slip-resistant
footwear; hearing protection; and gloves. Tie back
long hair and do not wear loose clothing or loose
jewelry.
•
Keep your hands, feet, other body parts, and
clothing away from rotating tines and moving parts
of the machine. The tines begin rotating when
you start the engine and may continue to rotate
momentarily after you shut off the engine.
g356250
•
Start the engine carefully according to instructions
in this Operator's Manual and with your feet well
away from the tines.
•
Use extreme caution when reversing or pulling
the machine toward you. To avoid getting pinned
against a structure, allow enough distance to
reverse direction near a wall or fence.
•
Keep bystanders out of the operating area. Keep
small children out of the operating area and under
the watchful care of a responsible adult who is
not operating the machine. Stop the machine if
anyone enters the area.
•
Before you start the engine, ensure that all drives
are in neutral and you are in the operating position.
•
Operate the machine only in good visibility and
appropriate weather conditions. Do not operate
the machine when there is the risk of lightning.
•
Do not attempt to adjust the machine while the
engine is running.
•
If the machine strikes an object or starts to vibrate
abnormally, immediately shut off the engine, wait
for all moving parts to stop, and disconnect the
wire from the spark plug before examining the
machine for damage. Vibration is often a warning
sign of trouble. Make all necessary repairs before
g356253
resuming operation.
•
Do not operate the machine at high transport
speeds on hard or slippery surfaces.
•
Look behind and down and use care when
reversing.
11
Publicidad
