Publicidad
Idiomas disponibles
Idiomas disponibles
Adjusting the Drag Stake
The drag stake helps regulate tilling depth and
prevents the tiller from jerking forward during
operation. Set the drag stake in the lowest position
to increase resistance to forward motion and to dig
deeper; raise the drag stake for transport.
1.
Move the machine to a level surface, shut off the
engine, and wait for all moving parts to stop.
2.
Remove the lock pin.
Figure 15
1. Drag stake
3.
Position the drag stake to the desired depth.
Note:
Adjust the drag stake 1 hole at a time and
test the tiller operation after each adjustment.
Raising the drag stake too high can result in loss
of control of the tiller.
4.
Secure the drag stake with the lock pin.
Tilling Soil
1.
Adjust the drag stake to the desired depth; refer
to
Adjusting the Drag Stake (page
2.
Squeeze the drive-control lever to engage the
tines.
3.
Till soil as required.
4.
Release the drive-control lever to disengage the
tines.
g356423
2. Lock pin
13).
After Operation
After Operation Safety
General Safety
•
Shut off the machine and wait for all moving parts
to stop before you leave the operator's position.
Disconnect the spark-plug wire, keep it away from
the plug to prevent accidental starting, and allow
the machine to cool before adjusting, fueling,
unclogging, servicing, cleaning, or storing the
machine.
•
Clean debris from the machine to help prevent
fires. Clean up oil or fuel spills.
Hauling Safety
•
Disconnect the wire from the spark plug before
loading the machine for hauling.
•
Use care when loading or unloading the machine.
13
Publicidad
