Publicidad
Idiomas disponibles
Idiomas disponibles
•
Do not overload the machine capacity by
attempting to till or cultivate too deep and at too
fast a rate.
•
Do not pick up or carry a machine while the engine
is running.
•
Exercise caution and be sure of your footing,
especially when backing up, to avoid slipping or
falling.
•
Be careful when operating the machine in hard
ground. The tines can catch in the ground and
propel the machine forward. If this occurs, let go
of the machine; do not try to restrain it.
•
Exercise extreme caution when crossing gravel
surfaces. Stay alert for hidden hazards or traffic.
•
Do not leave a running machine unattended.
•
Shut off the machine and wait for all moving parts
to stop before you leave the operator's position.
Disconnect the spark-plug wire, keep it away from
the plug to prevent accidental starting, and allow
the machine to cool before adjusting, fueling,
unclogging, servicing, cleaning, or storing the
machine.
•
Operate the engine only in well-ventilated areas.
Exhaust gases contain carbon monoxide, which is
an odorless, deadly poison.
•
Use only accessories and attachments approved
by The Toro® Company.
•
Do not change the engine governor settings or
overspeed the engine.
•
Always be sure of your footing; keep a firm hold on
the handle and walk, never run.
•
Allow the muffler and engine area to cool before
touching them.
•
The tines should not rotate when the engine is
idling; if they do rotate, contact your Authorized
Service Dealer.
•
If an object becomes lodged in the tines, shut off
the engine, disconnect the wire from the spark
plug, and allow the engine to cool before removing
the object.
•
Do not operate the machine on steep slopes. To
prevent overturning, operate the machine up and
down the slope.
Starting the Engine
1.
Set the engine on/off switch to the O
2.
Pull the recoil-start handle.
Note:
When you pull the recoil-start handle,
pull it lightly until you feel resistance, then pull it
sharply. Allow the rope to return to the handle
slowly.
Note:
attempts, contact an Authorized Service Dealer.
Shutting Off the Engine
1.
Release the drive-control lever.
2.
Move the engine on/off switch to the O
position.
3.
Wait for all moving parts to stop before leaving
the operating position.
Adjusting the Tail Mount
Position
Use the handle on the drag stake to rotate the hinged
tail mount to the Transport or Operating positions.
CAUTION
Rotating the hinged tail mount can create a
pinching hazard between the upper and lower
portions of the tail mount.
Keep away from the pivot points when
adjusting the tail mount position.
1. Transport position—rotate
the hinged tail mount
downward
position.
N
12
If the machine does not start after several
Figure 14
2. Operating position—rotate
the hinged tail mount
upward
FF
g356094
Publicidad
