Publicidad
Idiomas disponibles
Idiomas disponibles
Airfusion Aria Hugger Installation Instructions
INSTALL THE FAN ASSEMBLY TO THE MOUNTING BRACKET
Install the fan assembly to the mounting bracket (Fig.10):
•
There are 4 screws pre-installed on the mounting bracket:
Loosen two canopy screws with star washer (2) by half thread from the mounting bracket. (For L-shape
-
slot on canopy to be mounted).
Loosen two canopy screws (1) and remove from the mounting bracket.
-
•
Lift the hanging canopy of the fan assembly up to the mounting bracket and let the L-shape slot on the
hanging canopy go through the two canopy screws with star washer (2).
•
Turn the hanging canopy until it locks in place at the end section of the L-shape slot, ensure the star
washer are between the hanging canopy (3) and screw head. Secure it by tightening the two canopy
screws with star washer (2).
•
Secure and tighten the canopy screws (1) to the mounting bracket. The hanging canopy (3) shall have 4
screws (1) & (2) in total. Avoid damaging the electrical wiring prepared previously when hanging the
canopy.
•
Finally attach the canopy cover (4) to the mounting bracket, secure it by pushing the hooks of the
canopy cover into the slot holes of the hanging canopy and turn it anti clockwise.
BLADE ATTACHMENT (Fig.11)
1. Before installing the blades, remove the blade screws and flat washers from the bottom of fan motor.
2. Align the 2 holes on the blade with the 2 holes on the rotating member of fan motor assembly and using
the 2 blade screws in step 1, to secure the blade to the fan motor assembly.
Ensure all screws are tightened evenly to reduce the chance of warping or unbalancing. Take care not
to over tighten the screws, as this can damage the blades.
3. Once completed, repeat the process on the remaining blades.
6 | P a g e
INSTALLING THE FAN BLADE AND LIGHT KIT
Fig. 10
V 1 . 0 ( 0 7 / 2 0 2 1 )
Publicidad
