Sears Kenmore ULTRA WASH 665.1715 Manual De Uso Y Cuidado página 11

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Recommended
time intervals to clean your filter
Number of
If you only scrape before loading*
If you scrape and rinse
If you wash before
Loads Per Week
before loading
loading
8-12
Every two months
Every four months
Once per year
4-7
Every four months
Once per year
Once per year
1-3
Twice per year
Once per year
Once per year
_Manufacturer's
recommendation:
This practice will eliminate the water and energy that you use prepanng
your dishes. This will also
save you time and effort.
Very Hard Water
If you have hard water (above 15 grains), clean your filter at least once per month. Building up of white residue on your dishwasher
indicates hard water. You may bring your water samples to Sears to check hardness level. For tips on removing spots and stains, see
"Troubleshooting"
section.
Filter Removal
Instructions
1. Turn the Upper Filter Assembly 1/4 turn counterclockwise
and lift out.
2. Grasp the Lower Filter in the circular opening, lift slightly, and pull forward
to remove.
3. Clean the filters as shown below.
tab
Cleaning Instructions
IMPORTANT: Do not usewire brush, scouring pad, etc., as they may damage the filters.
Rinse filter under running water until most soils are removed. If you
have hard-to-remove
soils or calcium deposits from hard water, a
soft brush may be required.
To remove
Upper
Filter
Assembly
Filter Reinstallation Instructions
1. Noting the previous illustrations, place the Lower Filter under the Locating Tabs in the
bottom of the dishwasher so the round opening for the Upper Filter Assembly lines up with
the round opening in the bottom of the tub.
2.
Insert the Upper Filter Assembly into the circular opening in the Lower Filter.
3.
Slowly rotate the filter clockwise until it drops into place. Continue to rotate until the filter
is locked into place. If the filter is not fully seated (still turns freely), continue to turn the
filter clockwise until it drops and locks into place.
NOTE: The Upper Filter Assembly arrow does not have to align with the arrow in the
Lower Filter as long as the filter is locked.
Locating
tab
To replace
Upper
Filter
Assembly
IMPORTANT: To avoid damage to dishwasher, do not operate your dishwasher without the ULTRA WASH _ÈEfilters properly installed.
Be sure the Lower Filter is securely in place and the Upper Filter Assembly is locked into place. If the Upper Filter Assembly turns
freely, it is not locked into place.
11

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido