Publicidad
Idiomas disponibles
Idiomas disponibles
Kindly read the manual carefully before using.
Warning
1.
The installation and test of bathtub must be operated by qualified electrician or professional person
who assigned from dealers.
2.
The bathtub should be installed in the correct zone and that equipotential bonding is carried out.
3.
The floor has to be capable of supporting the expected load.
4.
Be sure to use the qualified water. And pH values and chlorine concentrations of water should be in
the level of standard.
5.
Do the cleaning and regular disinfection to keep the bathtub clear. See detail in part of CLEAN AND
MAINTENANCE. To keep the bathtub clear, and better to use a cover if it left empty for a long time.
6.
Using drainer system in bathtub to make water out. Be sure to drain water out after using in case
water freezing in winter.
Installation
1. Open the cartons to check whether the bathtub has defects, and the availability of fittings.
2. Put the bathtub into a pre-determined place, than adjust the feet to make the bathtub at a horizontal
position stabled.
Lead the drainpipe to the preformed floor drain. Then set the bathtub tube into the right place. Doesn't
extruding bending, chocking drain pipe, make sure the bailing smoothly. Carefully hand tighten the
white drainpipe until it stops. Don't over tighten. If possible, better to do it by silicone or seal strips to
avoid water leakage. (see P.S.)
Clean and Maintenance
1. Kindly using normal liquid detergent and soft cloth to clean the bathtub. Not allowed for the detergent
with acetone or ammonia water to clean. If there is glue leftover from adhesive tape on the surface of
bathtubs, soft cloth dipped with petrol is the best thing to wipe away.
2. If there is scratch on the bathtub surface, you can use waterstone abrasive paper in 1500#-2000# to
polish, and then spread some toothpaste, polish again by soft cloth, and then it will be same as new
one.
3. No need to clean very often for gold platting and chromium-plating parts.
4. Don't use rough tools and clean agent with chemical solvent or pellet to clean the surface of bathtub.
5. Don't use object with edges and corners, and cutting tools to knock or scratch the surface of bathtub.
6. Check the flow pipe and drain pipe often to make sure no water drops and bailing smoothly.
3
Publicidad
