Metra 95-7378B Instrucciones De Instalación página 3

KIT PREPARATION
Radio Trim Panel Installation
From the factory radio trim panel:
1. Remove (4) Phillips screws securing the
inner trim panel, then remove the panel.
(Figure A)
To the factory radio trim panel:
2. Secure the 95-7379B radio trim panel to
the panel using with the factory screws.
(Figure B)
Continue to Kit Assembly
(Figure A)
(Figure B)
KIT ASSEMBLY
1. Secure the radio brackets to the radio
using the screws supplied with the radio.
(Figure A)
2. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using the
proper mating adapter from Metra and/
or AXXESS. Test the radio for proper
operation.
3. Secure the radio assembly to the dash
using the factory screws.
4. Reassemble the dash in reverse order of
disassembly to complete the installation.
(Figure A)
REV. 1/6/2022 INST95-7378B
3