Avoid spilling liquids onto the unit. If a liquid is
accidentally spilled onto or if any metallic object
(such as paper clips, coins or staples) is
inserted into the unit, unplug it immediately
from the power source and contact Margules to
receive instructions.
7.
HEAT AND TEMPERATURE: Place the
equipment far away from heat sources such as
radiators, heat logs, stoves or other electronic
equipment (including amplifiers) that produce
heat.
8.
VENTILATION: The rack, shelf or special
furniture where you place the equipment must
have ventilation slots or openings in order to
protect the equipment from overheating.
Place the equipment with at least 6 inches (16
cm) free space from the top and with a space
behind it that allows a free flow of air.
9.
GROUNDING OR POLARIZATION: As a
safety feature, the unit is equipped with a
polarized alternating current line plug, which
has one blade wider than the other. This plug
can be inserted in the electric outlet only one
way.
If you cannot insert the plug completely into the
outlet, try inverting the plug.
If the plug still does not fit correctly, contact a
licensed electrician to update your obsolete
outlet. Do not remove or damage the safety end
of the polarized plug.
10. POWER SOURCES: Use the equipment only
with outlets that have the power supply
indicated in the label of the equipment. If you are
not sure about the type of power supplied in
your home, contact your local electricity
supplier.
11. POWER CORD PROTECTION: Fix the power
cords in such a way that there is no risk of them
being crushed, caught or squeezed by other
equipment
or
furniture.
attention to the ends of the cords, both the end
that goes into the outlet and the end that directly
comes from the equipment.
12. LIGHTNING: For best protection during an
electric storm or when the equipment is inactive
for long periods of time, unplug the equipment
from the outlet and disconnect the antenna or
cable decoder. This will help protect the
equipment from lightning and electrical surges.
13. ELECTRIC LINES: Do not place an external
antenna system near the aerial electric lines or
Particularly
pay
other electric power circuits. When installing an
external antenna system, you must be very
careful not to touch the electric lines or circuits
since contact with them may be lethal.
14. OVERLOAD: Do not overload the wall
outlets, extension cords or power strips, since
this increases fire and electrical shock hazards.
15. SAFETY VERIFICATION: After any service
or repair to the equipment, ask the service
technician to perform safety controls to make
sure the equipment is in proper working
condition.
16. IMPORTANT SAFETY NOTES:
CAUTION:
Any modification not expressly approved by
Margules will make the warranty of the
equipment void and may result in hazard for the
user.
•
Before connecting a new product such as
TH
the U-280 SC 30
Anniversary amplifier to your
audio or home theater system, turn off all other
equipment (preferably by unplugging them from
the AC power source).
Many audio components have automatic start
circuits that may activate during an installation;
this could cause damage to the electronic
components and/or speakers. This kind of
damage is not covered by the warranty of this
product and as such Margules specifically is
released of liability for said damages.
•
The detachable power cord supplied with
your equipment was specifically designed to be
used with this product; however, you may use
other better-quality power cords in order to take
the utmost advantage of the capabilities of this
equipment.
Ask your Margules distributor for advice on
power cords that may be used with your system.
For your protection, the amplifier is
•
equipped with an AC fuse (6A-SB) located on the
back of the chassis. This fuse may be replaced
by the user. In case the fuse is replaced and the
equipment does not turn on, contact an
authorized service representative. The spare
fuse must be always the one specified by the
manufacturer.
The electric wiring that runs inside the walls
•
must
have
the
proper
(Underwriters
Laboratories)
satisfactory compliance with all requirements
UL
certification
to
indicate
ENGLISH - 15