Margules U-280 SC 30 Manual Del Usuario página 16

set forth by the regulations in force, and belong
to the list authorized by the UL, CSA or other
regulation required by the UL, CSA, NEC or your
local construction code. Questions on electric
wiring must be submitted to a certified installer,
licensed electrician or low voltage contractor.
17. RECORDING OF CONTENTS PROTECTED
BY COPYRIGHT: Recording
protected material for a use other than personal
is against the law if done without permission by
the owner of said copyright.
18. INSTALLATION OF THE CATV SYSTEM:
The installer of the CATV system must follow the
provisions of article 820-40 of the NEC,
ANSI/NFPA 70, which
requirements for proper grounding installation
and particularly specifies that the earth terminal
of the grounding system must be connected to
the grounding system of the building as near to
the entering point of the cable as practically
possible.
19. FCC INFORMATION
COMMUNICATIONS COMMISSION) FOR THE
USER: This equipment generates and may
radiate radiofrequency energy and if not
installed and used according to the instructions
it may cause interference
communications.
These limits are designed to provide reasonable
protection against interferences in a residential
installation. However, there is no guarantee that
interferences in any given installation will not be
produced.
If this equipment causes damaging interference
to radio or television reception that may be
determined by turning the equipment on and off,
we recommend the user to try and correct the
interference through one or more of the
following actions:
Re-orient or relocate the receiving antenna
•
• Increase the separation
equipment and the receiver
Connect the equipment and the receiver to
•
outlets in separate circuits
20. EXTERNAL ANTENNA INSTALLATION /
SAFE ANTENNA AND CABLE CONNECTION: If
an external antenna or cable system is
connected to the equipment, make sure the
antenna or cable system is grounded to provide
protection against static charges and surges.
Article 810 of the National Electrical Code,
ANSI/NFPA 70 (in Canada, part 1 of the Canadian
Electrical Code) provides information on the
of copyright-
sets forth the
(FEDERAL
to radio
between the
correct grounding of the mast and support
structure, the connection of the grounding
conductors to an antenna discharge unit, the
size of the grounding conductors, the location
of the antenna discharge unit, the connection to
the grounding electrode system and the
requirements for the grounding electrode
system.
The external antenna system must be placed as
far away from electrical lines as possible and
where it may never come in contact with these
power sources in case of fall. When installing an
external antenna, special attention must be paid
to avoid contact with electrical lines, circuits or
other sources of energy since this could prove
to be lethal.
Due to the danger involved, the antenna
installation must be
professional.
performed by a
ENGLISH - 16