Publicidad
Idiomas disponibles
Idiomas disponibles
954251.book : I95425us.fm Seite 2 Montag, November 23, 1998 10:28 AM
D
C
A1
A
B
F
E
H
G
Installation
See dimensional drawing on fold-out page I.
Before mounting faucet:
Pre assemble components.
Side valves
[2]
The distance from the top edge of the snap insert
to the bottom of the escutcheon must be 2", see
fig. [2]
Left close valve should be mounted on the right
(cold) side. Right close valve should be mounted
on the left (hot) side.
Valves are marked with a "L" (left close) or "R"
(right close) on the top edge of the ceramic cartridge.
Vacuum breaker
1.Insert the vacuum breaker body with seal (A)
[3]
and nut (B) through the basin hole from below,
see fig. [3].
2.Slide on seal (A1) with ring (C) and screw on
nut (D).
The distance from the top of the body to the
bottom of the ring must be 2 3/16", see fig. [4]
3.Secure vacuum breaker body to the basin by
tightening nut (B), see fig. [3].
4.Slide on tube (E) and cover (F), see fig. [5].
[4]
5.Tighten the connection tee (G) to the vacuum
breaker body with connection nut (H).
[5]
English
2
Publicidad
