Corghi ProLine 60 Manual De Uso página 44

The installation methods of the wheel：Positive
positioning, negative positioning & flange disk
when handling the middle and big sizes of tires.
You can select the methods according to the
different conditions.
6.3.2.1 SMALL CAR WHEEL POSITIVE
POSITION
Positive positioning is the normal method. It is
featured with simple and quick operation. It is
mainly suitable to the common steel rim and
aluminum alloy rim with small deformation.
Main shaft à wheel (direction of the rim installation
surface is inside) à cone à quick nut
6.3.2.2
When the deformation of the outside of the whe-
el, adopt this method to positioning to grantee
the accurate positioning of the steel rim inner
hole and main shaft. It is suitable to the steel
rim, especially the thick ALU
Main shaft à lower spring à suitable cone
wheel à bowl à quick nut
44
6.3.2.3 FLANGE DISK POSITIONING
(OPTIONAL)
Suitable to the big tire assemble
Main shaft à lower spring à suitable cone
wheel à bowl à quick nut
NOTE: The choice on the cone should be adap-
ted to the rim center hole and pay attention
to its direction. Or it will cause the inaccurate
measurement.
6.4 INPUT VALUE
6.4.1 Input DIS (Distance)
Pull the scale to the inner position to add the
weight and press the key
to input the DI value into the display. At this
moment, the display will display [DIS]:[XXX].
And the default system is mm.
6.4.2 Input Br (RIM Breadth) Value
Use the Br measurement caliper to measure the
ProLine 60 - Operator's Manual