Publicidad
Idiomas disponibles
Idiomas disponibles
Chapter 5 Cleaning and Maintenance
1. Before cleaning the product, be sure to remove the electrical head and disconnect
the power supply.
2. Please clean the product in time after using.
3. When cleaning, please rinse the cup body and accessories with water and wipe them
dry. The blade is very sharp.
4. The outside of the motor can be wiped with a damp cloth. Do not put the main body
into the liquid or wash it in water or other liquid.
5. Store the product in a dry place and avoid direct uv exposure
6. Make sure the product is clean and dry before storage.
The fault
phenomenon
During the first few
USES of the product;
the motor gave off
an unpleasant smell
Stop in service
Abnormal vibration
or loud noise
Card knife
Note:
• The above is the common fault analysis and troubleshooting method, for other faults,
please contact the company's customer service department, or directly to the company's
designated repair point for repair, do not disassemble repair.
Chapter 6 Fault Analysis
Cause analysis
If the product still emits this
odor after repeated use,
please send it to the nearest
repair point for testing
1.The voltage is too low
2. Motor temperature control
protection
1. The skein knife rest is not
installed in place
2. Product placement is not
stable
3. The voltage is too high
4. Overeating
The blade gets tangled or
stuck in the food
59
troubleshooting
The new motor is used normally
at first
1.Check if the voltage is too low
2. Stop using for 20-30
minutes
1. Take out the ingredients and
install the skein knife rest in
place
2. Stable product placement
3. Check if the voltage is too
high
4. Turn off the switch, disconnect
the power and remove the
excess ingredients
Turn off the switch, disconnect
the power, remove the
ingredients and cut into small
pieces
Publicidad
