Publicidad
Idiomas disponibles
Idiomas disponibles
HOW TO TAKE CARE OF ISUP BOARD
DO'S
CLEANING
Clean the board after
each use with freshwater
and mild soap.
KEEP IT DRY
Dry the board after each
use, especially before
storing to avoid mould
damage.
FREQUENT USE
Use the board frequent-
ly as long-term storage
may cause adhesive
failure.
REGULAR
MAINTENANCE
Regularly check for
cracks, scrapes, or any
other issues and repair
if necessary.
FAQs (Frequently Asked Questions)
Q: How much air should I pump into my board, and how long does it take
to inflate?
A: The maximum pressure is 15 – 18 PSI (8 PSI for MEGA, 10 PSI for HYPER inner
chamber, 3 PSI for DRIFT side chambers), any higher you risk over inflating and
damage. Depending on the size of your board it can take anywhere from 5 to 8
minutes.
Q: When detaching the pump from the board, the air starts to release from
the valve. How do I stop this from happening?
A: The air is releasing as the valve spring pin has been left in the deflating position.
Simply push down and turn the pin until it lifts up into the inflation position and
stops air from releasing; continue to inflate the board until up to pressure.
16
DON'TS
DON'T USE AN AIR
COMPRESSOR
You can easily over-inflate
the board by using an air
compressor and void the
NO DRAGGING
Don't drag the board as
sharp debris may
puncture it.
AVOID DIRECT
SUNLIGHT
Keep the board under
shade when not in use
with a working
pressure less than
50%-60% of the max.
air pressure.
AVOID TEMPERATURE
EXTREMES
Keep the boards sheltered
away from temperature
extremes and humidity.
Store at room temperature
between 0℃ - 40℃.
warranty.
Publicidad
