Aqua Marina BREEZE Manual Del Usuario página 19

3. Check the rubber ring to make sure that it is in the correct position,
tight around the valve and there is no debris in the way
4. Be sure the pin spring is functioning properly and that there are no
cracks along the edges
5. Ensure there are no strings from the drop stitching material
6. Note the bottom piece of the valve is not attached to anything
7. Fit the valve back into your board
8. Align all the threads and twist to tighten
9. Once the valve is hand tight, use the valve wrench to seal completely
NOTE: Correctly use the wrench by pressing it with
one hand on top.
Rubber Ring
19