Publicidad
Idiomas disponibles
Idiomas disponibles
TILT-BACK DESIGN
SWR's Megoliath, Goliath Senior, Big Bertha and Henry The 8x8 feature a tilt-back design for easy transportation. To take
advantage of this feature, firmly grasp the bar or handle (depending on the model) found on the top rear surface of the enclo-
sure. Carefully pull the top of the cabinet toward you so that the enclosure balances on its heavy-duty caster wheels. When a
comfortable balance is achieved, push forward in the direction you want to move the enclosure.
REMOVABLE CASTER WHEELS – GOLIATH III AND 12-STACK MODELS
The Goliath III and the 12-Stack are shipped with a set of four, heavy-duty, removable caster wheels. SWR uses only closed shaft
sockets so as to prevent air leaks or unwanted noise when the enclosure is in use. To install the caster wheels on these speaker
cabinets, carefully turn the enclosure upside down (or on its side) so that the caster base/sockets are visible. Insert the shaft of
each caster wheel into a socket on the underside of the speaker cabinet. When all four wheels are firmly in place, return the cabi-
net to its upright position and you're ready to roll. You can leave the casters in place during performance, but it's recommended
that they be removed prior to setting up your amplification system. This will allow your cabinet to couple to the floor, which can
be helpful in extending your system's bass response. Please note that the ball bearing type caster wheels provided with your
Goliath III or 12-Stack cabinet may require periodic replacement depending on usage and care. Replacement caster wheels can
be purchased from the SWR Service Department.
INPUT PANEL DIAGRAMS
All models (except Big Ben, 12-Pack, 12-Stack and Megoliath)
Tweeter Attenuator
Control
1/4" Input
1/4" Output
Speakon Input
Speakon Output
Professional and Custom Pro Specialist Series • 7
Publicidad
