Princess Smart Air Conditioner 9000 Manual De Usuario página 12

Instruction manual
TROUBLESHOOTING
Troubles Possible Causes
The unit does not start when •
pressing power button.
•
•
The unit doesn't cool enough. •
•
•
•
•
Noisy. •
•
E0 Code •
E1 Code •
E2 Code •
E3 Code •
E4 Code •
12
Suggested Remedies
Water full indicator lamp • Drain the water out of the
blinks and water tank is full. water tank.
Room temperature is higher • Adjust the temperature.
than the setting
temperature.(Electric
heating mode)
Room temperature is lower
that the setting temperature.
(Cooling mode)
The doors or windows are • Make sure all the windows
not closed. and doors are closed.
There are heat sources • Remove the heat sources if
inside the room. possible.
Hot air exhaust hose is not • Connect or clean the hot air
connected or blocked. exhaust hose.
Temperature setting is too • Reset the temperature.
high. • Clean the air inlet.
Air inlet in blocked.
The ground is not level or • Place unit on a flat, level
not flat enough. ground if possible.
The sound comes from the
flowing of the refrigerant
inside the air conditioner.
Room temperature sensor • Replace room temperature
failed. sensor.
Condenser temperature • Replace condenser
sensor failed temperature sensor.
Water tray full when cooling • Take off rubber stopper and
empty the water.
Pipe temperature sensor • Replace pipe temperature
failed. sensor.
Water tank full • Please empty the water
tank.
THE PRODUCT OR EQUIPMENT CONTAINS
FLUORINATED GREENHOUSE GAS.
Art.nr.
Coolant:
Quantity in kg:
Global Warming Potential:
CO2 Equivalent in tonnes:
Art.nr.
Coolant:
Quantity in kg:
Global Warming Potential:
CO2 Equivalent in tonnes:
DECLARATION OF CONFORMITY
• Hereby, Smartwares Europe declares that the radio equipment type
352900 / 353200 are in compliance with Directive 2014/53/EU
• The full text of the EU declaration of conformity is available at the
following internet address: www.princesshome.eu/doc
352900
R290
0.212
3
0.000636
353200
R290
0.226
3
0.000678