Chicco BebeCare Seat Up Manual De Instrucciones página 39

simultaneously adjusted using the headrest
and belt adjustment button (A) (Fig. 41).
To increase the height of the headrest release
the safety belts by pressing button F and, at
the same time, hold the two child car seat
harnesses under the shoulder straps and pull
them towards you. Then lift button A.
To lower the headrest press button A.
To adjust them correctly, the headrest must
be fitted so the harnesses come out from the
backrest at the height of the child's shoulders
(Fig. 42).
12. ADJUSTING THE CHILD CAR SEAT
BUCKLE
The child car seat buckle can be adjusted to
two different positions: A and B.
• Position A: use for Gr. 0+ (from 0 up to 13
kg) and Gr. 1 (9-18 kg).
• Position B: use for Gr. 2 (15-25 kg).
The buckle is in position A when purchased.
When the car seat is used for Gr. 2 (15-25 kg) it
is necessary to switch to position B.
Remove the padded crotch strap (I). Turn the
metal connector and switch from position A
to position B (Fig. 43). After this check that the
belt has not rolled up. Pull the buckle several
times to check it is inserted correctly. After ad-
justing, replace the padded crotch strap.
13. REMOVING 5-POINT SEAT BELTS
Loosen the 5-point seat belts as much as pos-
sible using button F.
Adjust the headrest to its maximum height using
the headrest and belts adjustment button (A).
Turn the child car seat so you are looking at
the back of the seat.
Remove the two belts from the metal connec-
tor (Fig. 44).
Position the metal connector in its specific slot
(Fig. 45).
Open the cover, remove the shoulder straps,
separating them by pressing on the connect-
ing ring (Fig. 46).
Remove the belts and take off the shoulder
straps, conserving for future use.
WARNING! When refitting 5-point belts re-
member to pass the belts above the metal pin
(Fig. 47). Open the buckle (Fig. 48). Roll every
belt and the corresponding flap up (Fig. 49a)
and place the rolled up belt in the compart-
ment in the backrest (Fig. 49b). Remove the
padded crotch strap (I). Remove the buckle
from the upholstery (Fig. 50 a). Turn the buckle
90° placing the belt into the opening and pull-
ing the buckle upward (Fig. 50 b). Remove the
polystyrene, insert the buckle in its seat and
place the polystyrene again (Fig. 50 c).
14. SEATING THE CHILD IN THE CHILD CAR
SEAT
Before sitting your child in the child car seat,
press the belt adjustment button (F) and, at
the same time, hold the two child car seat
harnesses under the shoulder straps and pull
them towards you to slacken them.
Unfasten the buckle (J) of the child car seat
belts by pressing the red button and pull the
harnesses in an outward direction. Now you
can sit your child in the child car seat.
Position the crotch strap correctly (I), take the
belts, overlap the two buckle straps (Fig. 51-
52) and push them together firmly inside the
buckle slot until you hear a loud click (Fig. 53).
15. CLEANING AND MAINTENANCE
MAINTENANCE
Cleaning and maintenance operations must
only be carried out by an adult.
How to clean the fabric cover
The child car seat's fabric cover can be re-
moved and washed by hand or in a washing
machine at
30°C. Please refer to the care label for instruc-
tions on cleaning the seat fabric.
30° C
30° C
39
Machine washable at 30°C.
Do not bleach
Do not tumble dry
Do not iron
Do not dry clean