Publicidad
Idiomas disponibles
Idiomas disponibles
AIR PURIFIER SET-UP
NOTE: Follow these instructions for
best results.
• Place unit at least 2 feet (½ meter) from
the wall.
• Keep unit away from drafty areas.
• Keep curtains away from unit, as they
may interfere with air intake/outlet.
• Place unit on a stable surface with plenty
of air circulation.
1. Remove protective film from the
control panel.
2. Open filter door.
AeraMaxSE_412541_3L_021122.indd 6-7
3. Take out filter and remove plastic filter
bag.
4. Place filter closed-side-down and press
on plastic edges until fully seated back in
the machine.
5. Close filter door securely.
6. Plug in the power cord to a wall outlet.
7. Turn unit on. Unit will beep.
For approximately the first 4
minutes after turning the unit on,
the auto icon will flash while the unit
measures air quality.
6
DISPLAY PANEL
1
2
5
1.
TIMER - Press this button to select between timer settings. Timer can be set to turn the unit
off in 2, 4 or 8-hours, indicated by the LED light. The timer can also be turned off by cycling
past the 8-hour setting.
2. MODE - Press this button to select between this unit's 3 operating modes:
Manual - fan speed is controlled by the SPEED button. Neither of the MODE lights are lit.
Auto - fan speed is automatically adjusted according to the air quality level. The "A" LED will
be lit.
Sleep - fan speed is set to low, the screen will go dark. The "SLEEP" LED will be dimly lit.
3. SPEED - Press this button to select between this unit's 3 fan speeds.
4. POWER - When unit is plugged in, the unit will automatically enter standby mode and the
POWER button will be dimly lit.
Press this button when in standby mode to turn on the unit.
While powering up, the unit will beep once, the AUTO and SPEED 1 LED's will be lit.
The green LED on screen will flash and show a 60 second countdown for particle sensor
calibration. After the 60 seconds, the PM2.5 value on screen and the unit will enter AUTO
mode.
While the unit is on, press this button to put the unit back into standby mode. The unit will
beep once during this process.
5. FILTER REPLACEMENT REMINDER - Once the filter has reached the end of its life, the
AUTO and SLEEP LED's will flash to indicate it is time to replace the filter.
After replacing the filter, to reset the filter light, press down and hold the MODE and SPEED
buttons at the same time for 5 seconds. The unit will beep once and the AUTO and SLEEP
LED's will flash 3 times.
6. CHILD LOCK - Press the SPEED and POWER buttons at the same time for 5 seconds to
activate the child lock function. The machine will beep one time and the child lock symbol will
appear on screen.
Other buttons will no longer work, and if pressed, will only flash the POWER LED 3 times.
To disable the child lock function, press SPEED and POWER buttons at the same time for 5
seconds. The unit will beep once and the child lock symbol will disappear.
3
4
7
2/11/22 4:02 PM
Publicidad
