Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
AUTOMATIC OPERATION
The unit is set to default to automatic
operation when it is first turned on. The air
purifier will automatically sense the amount
of impurities in the air, and adjust the fan
speed to keep your air purified.
MANUAL OPERATION
After you turn on the unit, you can switch
to manual operation by tapping the MODE
button.
• LOW, MEDIUM, OR HIGH SETTINGS
These levels are recommended for
standard daytime use. HIGH will activate
automatically when sensors detect poor
air quality.
AeraSmart™ SENSOR
Air quality indicator shows levels of air quality.
Green level indicates air is clean.
Amber level indicates air quality is poor.
Red level indicates high level of pollutants
in the air.
AeraMaxSE_412541_3L_021122.indd 8-9
8
CARE AND MAINTENANCE
CLEANING
• Clean unit as necessary by wiping with a
dry, soft cloth; for stubborn stains, use a
warm, damp cloth.
• Do not use volatile fluids such as
benzene, paint thinner, or scouring
powder, as they may damage the
unit surface.
• Keep the unit dry.
Filter Replacement
The flashing AUTO and SLEEP LED's will
signal when to replace the combination
filter. The replacement period will vary
depending on the hours of use and air
quality. However, under normal usage, it will
need to be replaced annually.
Do not wash and reuse the True HEPA
or Carbon Filters—they will not work
effectively. Only use Fellowes brand
AeraMax™ replacement filters.
WARNING:
Before replacing any
filters, make sure to remove the
power plug from the wall outlet.
Replacement Procedure
1. Open filter door.
2. Remove and dispose of old filter.
3. Remove any packaging wrap from the
new filter(s).
For replacement filter part numbers, see
page 4.
4. Place the new filters in the main unit.
(Closed side of the filter faces down).
Press on plastic edges of the filter until
firmly seated in the machine.
5. Close filter door securely.
6. To reset the filter light once a new Filter
is installed:
a. B e sure that drawer is closed.
b. Turn on the unit.
c. T o reset the filter light, press the
MODE and SPEED buttons at the
same time for 3 seconds. This will
turn off the lights and reset the filter
life timer.
9
2/11/22 4:02 PM
Publicidad
