Publicidad
Manage Cables
1.
Remove the cable covers
.
C
IMPORTANT: Fully extend
arm assembly
10
to ensure
enough slack in cables.
2. Route your cables through the
arm assembly
10
shown —
to avoid pinching.
3. Reattach the cable
covers
over the cables.
C
TV Adjustments
TILT ADJUSTMENT
Your TV should adjust easily when moved, then stay in place. If your TV is too loose or too tight, adjust
the side tension knob
by hand or use hex key
T
NOTE: Once your TV is in place, tighten the tension knob
NOTE: Additional tension can be applied using hex key
LEVEL ADJUSTMENT
EXTEND / RETRACT -- ONLY IF NECESSARY
Your TV should adjust easily when moved, then stay in place. ONLY if needed, adjust the
extension/retraction arm tension with screw
CAUTION:
Avoid potential personal injury or property damage!
DO NOT remove bolts
, only turn enough for slight adjustment.
R
LATERAL SHIFT
CAUTION:
Avoid potential injuries or property damage!
Do NOT adjust the arm position from center for concrete
10
applications. Arm
MUST remain centered in wall plate
for all concrete applications!
08
1. Remove your TV (PAGE 9).
2. Open the cover plates and remove two screws
12
screws
to release arm assembly
3. Reposition the arm assembly
10
on the wall plate (STEP 3. 1 ).
11
4. Reattach the two screws
and two screws
and close the cover plates.
10
5. Hang your TV onto the arm assembly
REMOVING THE TV
1
C
10
C
14
for additional tightening.
to prevent unwanted movement.
T
14
.
CAUTION:
13
Screw
13
MUST
be loosened before
turning screw
.
L
1. Loosen
screw
13
.
using a 1/8 inch hex key (not supplied).
R
HEAVY! You may need assistance with this step.
11
and two
10
.
10
12
(STEP 3. 1 )
1
following STEP 3.2.
a
HEAVY! You may need assistance with this step.
2
13
1
C
2. Adjust the leveling
of your TV by turning
L
the level screw
12
08
2
c
1
b
3
11
2
b
14
3
05
14
2
T
14
L
3. Retighten
screw
.
R
2
a
5
a
10
5
b
3
C
13
13
.
12
08
4
b
11
14
4
a
4
9
Publicidad
