Rear Panel - DJ-Tech i-Mix Reload MKII Manual De Instrucciones

CONNECTION
POWER CONNECTOR – Plug in power adapter here. DC adaptor can be used when the USB port cannot
7.
provide enough power to the unit. Please use only a 6V DC
POWER SWITCH (Adaptor / OFF/ USB power) – Set the switch to AC ADAPTOR when using external DC
8.
adaptor (not included), set to USB BUSS POWER when using power provided from the computer via USB.
USB CONNECTOR – Used to connect a computer. It is recommended to use the USB Cable included.
9.
Long or low quality USB cable may make the unit unstable.
C.F CURVE CONTROL – Adjusts the shape of the crossfader curve from a quick cut for scratching or to a
10.
longer fade for mixing.
TOUCH SENSOR LEVEL CONTROL – Adjust the sensitivity of the jog wheel touch sensor.
11.
OUTPUT JACKS – These jacks send a left and right analog output signal from the USB audio interface.
12.
Use the supplied RCA cables to connect these outputs to a main stereo system, like an amplifier or active
speakers.
INPUT JACKS – You can connect playback devices to these input jacks, such as CD players, turntables,
13.
SD players or USB players. These connections are for the inputs to the USB audio interface.
When connecting phono output turntables, be sure the corresponding switch is in the "PH" position.
When connecting line level output devices, be sure the corresponding switch is in the "LN" position
GND (GROUND TERMINAL) – Be sure to connect turntable ground leads to the available ground terminals.
14.
This will reduce the humming and popping noises associated with magnetic phono cartridges.
CHANNEL LINE LEVEL SELECTOR - These switches are used to select the line levels type of the related
15.
Phono/Line jacks.
Always be sure main power is shut off before switching the Line Level Selector.
OPERATIONS
1. Install the DJ software from the software CD included.
2. Install the ASIO driver for i-Mix Reload MKII from the Software CD "Drivers" folder. (ASIO Driver also
available on http://www.djtechpro.com
3. You may need to power on/ off the i-Mix Reload MKII when installing the driver.
4. Open the DJ software.
5. Start up the software to perform settings with the i-Mix Reload MKII.
The software may not recognize the i-Mix Reload MKII if it is connected to the computer after the
software has started.
6. Operations after the system recovering from power saving mode is not guaranteed.
Please power off and on again the unit when the system is recovered from power saving mode.
7. I-Mix Reload MKII can be used with many other DJ software products that have a MIDI LEARN function. The i-
Mix Reload MKII can control all software that has this function. i-Mix Reload MKII can be used to control
parameters of the software. Please visit http://www.djtechpro.com for supported DJ software like Traktor Pro.
Some mapping files are also available there.
The MIDI LEARN setting for each software is different; please refer to each software's manual for further
instructions.
7 8 9 10 11
)
12 13 14 13
adaptor.
3

REAR PANEL

15