Publicidad
Idiomas disponibles
Idiomas disponibles
Greengate
Sample Placement Diagram
(For Example Purposes Only)
Wall/Corner Mount
Additional
Occupancy Sensor
Wallstation
General On
AV Mode
Whiteboard
Quiet Time
Raise
Lower
Daylight
Sensor
The Room Controller is a room based system that simplifies
design, code compliance and installation. The controller
connects to occupancy sensors, daylighting sensors,
wallstations and receptacle control accessories with provided
Click & Go QuickConnect cables, providing a completely
operational, out-of-the-box solution. Control up to three
switched and three dimmed loads (dependent on model
ordered) without the need for post-installation programming.
Additional advanced integration easily accomodates Demand
Response, Alert Mode, A/V Mode and Time Clock requirements.
This document shows installation details regarding the Room
Controller and accessory products.
CAUTION
Bonding between conduit connections is not automatic and
must be provided as part of the installation.
Failure to install the Room Controller in the suggested location
(above the entry door) may lead to the provided QuickConnect
cabling being too short to reach the intended accessory loca-
tions.
White
Red
Black
Green
A/V
Mode
Demand
Response
Alert
Mode
Time
Clock
Energy Options DIP Switch
Demand Response
Default 10%
20%
30%
40%
0-10V Dimming Outputs
+
Dimmer 3
9850-000362-06 page 3
October 2022
Room Controller
(Above Entry Door)
Entry
General On
Off
Wallstation
6
Switchpack
Receptacle
BMS/Out
5
Sensors
Sensors
Slider
Station
4
Wallstations
-
+
-
3
+
-
+
-
+
2
1
Occupancy
Not Used
1 2
3
4
Occ
Vac (default)
-
-
-
+
+
Dimmer 2
Dimmer 1
Dimmer 3
-
Dimmer 2
-
Dimmer 1
-
+
+
+
0-10V Dimming
Room Controller Plastic Enclosure (Model RC3DE shown)
Room Controller Metal Enclosure (Model RC3DE-PL shown)
Specifications
Input/Output Voltage
Maximim Combined Load
Ballast:
Incandescent:
Motor Load:
Emergency Output: (RC3DE only)
Ballast:
Incandescent:
Class 2 Dimming Output
Operating Environment
Room Controller
120/277 VAC 50/60Hz
20A
20A (LED)
15A
1 HP @ 120 VAC
3A (LED)
3A
0-10 VDC, sinks up to 100mA
per output for control of up to 50
compatible ballasts/drivers.
32° F to 104° F (0° to 40° C)
For indoor use only.
www.cooperlighting.com
Publicidad
