Publicidad
1.
ING.
General indications.
Thank you for choosing us. Now you can enjoy all the benefits and pleasures of hydromassage. Please read the instruction manual
carefully before the installation and use of the product.
Consult your doctor before using the hydromassage if you: are pregnant, suffer from high or low blood pressure, have a heart condition
or diabetes. It is recommendable to build up from initial short sessions to longer ones over a period of time. In the case of technical
problems, doubts or to find out more about the validity and scope of the product guarantee, please contact our technical service.
Warnings.
Installation have to be carried out by qualified personnel.The electrical installation and first trial have to be carried out by a qualified
electrician, who can check and certify the electrical circuit before and after carrying out the connection of the product.
If any component is damaged during the installation it is the installer's responsibility.
On unpacking the product check for any defect. Avoid cutting or breaking the electric cables. If the cable is damaged, it should be
replaced by the manufacturer, the after-sales service or by a qualified technician in order to avoid any danger.
Ensure that the electrical sockets correspond to the technical information with the product.
•
The electrical system should run on 230V. It is obligatory to install a 6A thermo magnetic circuit breaker and a Residual Current
Device (RCD) with a nominal current not higher than 30mA. (Both switches should be located away from the bathroom). Minimum
length of cable should be 2m.
•
The parts which contain active parts, except those fed with very low security voltage which doesn't exceed 12V., should be out of
the reach of a person in the bath.
•
The earthed apparatus should be permanently connected to the electrical supply.
•
The parts which incorporate electrical components, except the remote control, should be located or fixed in a way that they cannot
fall into the bath.
•
A cut off system should be incorporated into the fixed cables.
•
For the electrical connection it is essential to incorporate an isolator switch which ensures an all-pole cut off, directly connected to
the feed-in terminals and should have a contact separation in all the poles, which causes a cut off under category III conditions of
overloading, in an area which complies with all the security prescriptions in the bathroom.
•
According to the regulations in use, the switch and the other electrical devices should be placed out of reach of the person using
the bath (this is related to the volume limit of the REBT).
Protect the acrylic surface of the product during the installation and avoid it being hit. To move the hydromassage hold it by the sides,
never the conduits.
The surfaces where the product is going to be installed should be fully finished (with your chosen surface) and perfectly flat and squared.
The company does not install any of the products in our catalogue although for the comfort of our clients we have a number of totally
independent collaborators (referred to for practical purposes as S.A.T.). These independent collaborators bill the client directly for their
services (if the client decided to contract their services through our company or other means), and are completely responsible for the
work they do. The costs due to S.A.T. will only be met by our company when it is acting as an AFTER-SALES SERVICE, in the case that the
product is covered by a valid GUARANTEE after the verification and inspection of a manufacturing fault, by the technical department of
this company, indicating in detail, with the S.A.T. being equally responsible for its services.
This appliance can be used by children over 8 years of age, or by persons with reduced physical, sensory or mental capabilities or
lack of experience and knowledge if they have been clearly informed about the operation of the appliance and the possible dangers
involved.
Children must not play with the appliance. Cleaning and user maintenance must not be carried out by children without supervision.
The company is not responsible for injuries caused by the incorrect use of its products, nor for products which have been modified or
repaired by non-authorized personnel. Any damage to components during installation is the responsibility of the technician/person ins-
talling the product. Once the product has been unpacked, check it thoroughly. Try to avoid cutting or breaking electric cables. If there is
any fault in the wiring, it must be repaired by a professional. To move the product, hold it by the sides and never by the hydromassage
conduits. Protect the acrylic surface during installation and avoid knocking the hydromassage in any way. The surface or surfaces where
the apparatus is to be installed should have the appropriate covering already in place and be perfectly level and squared.
Check that the water system is working correctly. The first step before installation of the product equipped with our taps, is to purge the
tubes. Incorrect installation through the omission of this step will void the guarantee. The installer will be responsible for checking the
hydraulic system.
Never turn on the pump until the water level has completely passed the level of the jets. Never obstruct the openings of the hydro-mas-
sage while the pump is working.
Avoid the use of detergents which cause foam, organic mixtures or bath salts which are not completely soluble.
Before starting a session check the water temperature to ensure that it is never higher than 40ºC.
The company reserves the right to modify any of its products as well as the installation and users manuals of said products without any
obligation to forewarn or substitute.
5
Publicidad
