Defiant DF-6019-WH-B Guía Para El Uso Y Cuidado página 10

Code Setting
1
Locating the Dip Switches
It is recommended to only change one code position at
a time and then check to see if system is functioning
properly.
On the motion sensor (A), open the battery
cover and remove the batteries to locate the
dip switches.
Unplug the plug-in control (B) and locate the
dip switches on the rear.
DAY NIGHT
NIGHT ONLY
1 2 3 4
DETECT
CODES
A
3
Changing the Code Setting
The motion sensor (A) and plug-in control (B) both
have four different dip switches. Dip switches 1
through 3 are used for setting the code. Change the
code whenever the plug-in control (B) is receiving
interference from another transmitter.
Change the same dip switch setting on both
the motion sensor (A) and the plug-in control
(B). Example: Move dip switch 1 to the "ON"
position.
NOTE: Dip switch 4 sets the group (A or B). This dip
switch must match for the two units to communicate.
2
Changing the Group Setting
If more than one system of motion sensing controls
is desired, use the 4th dip switch to change the
group setting. This allows multiple systems to work
separately from each other.
Change the 4th dip switch on both the motion
sensor (A) and the plug-in control (B) to
change the units to another group setting.
B
10
NOTE: The motion sensor (A) and plug-in control (B) must
have the same code and group setting to work together.
Motion sensor
Plug-in control
Group A
Group B