Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting (continued)
Problem
The light comes on or the alarm
sounds for no apparent reason.
The lights stay on continuously.
The lights ash on and off.
Possible Cause
The motion sensor may be sensing
small animals or automobile traf c.
The "RANGE" dial is set too high.
The outside temperature is much
warmer or cooler than a person's body
heat (summer or winter).
There was a short term power outage.
The plug-in control is receiving interfer-
ence from another transmitter.
The motion sensor may be picking up
a heat source like an air vent, dryer
vent, or brightly painted, heat-re ective
surface.
The bypass switch on the plug-in
control is set to "MANUAL".
Weak batteries are in the motion
sensor.
Signals from the motion sensor are
being blocked, or the motion sensor is
out of range.
The dip switches on the motion sensor
and plug-in control do not match.
Heat is being re ected from other objects
and may be turning the motion sensor on
and off.
9
Reposition the motion sensor.
Please contact 1-866-308-3976 for further assistance.
Solution
Re-aim the motion sensor.
Decrease the "RANGE"
setting.
Decrease the "RANGE"
setting.
The next transmission from
the motion sensor will reset
the plug-in control to the
correct state.
Change the code setting on
the motion sensor and the
plug-in control. See Code
Setting on page 10.
Decrease the "RANGE"
setting or reposition the
motion sensor.
Switch the bypass switch to
"AUTO". See Adjusting the
Bypass Switch on the Plug-
In Control on page 7.
Check battery charge and
replace if necessary.
Check for metal objects
that could block the signal,
or reposition the motion
sensor.
Verify the code settings
on the motion sensor and
plug-in control are set the
same.
HOMEDEPOT.com
Publicidad
