Gardigo 60062 Manual De Instrucciones página 11

4. Contents
• Cat-Repellent
• Mounting material
• Instruction manual
5. Getting started
Cats are one of the most popular pets and are always around the house and the garden.
But there are always some areas that they should not be in, such as larders, bedrooms
or sand pits. The Gardigo Cat-Repellent registers all animals passing by within a di-
stance of 7 m and at an angle of 70°. As soon as the motion sensor is triggered, the
device will emit an ultrasonic sound varying between 55 kHz. These frequencies are
uncomfortable and disturbing to cats. Within a short period of time, they will avoid
the area.
Putting in the batteries
Of the device requires 6 x Mignon (AA, 1,5 V) batteries . Please do not use rechargeable
batteries, as these very often have a lower voltage. This can strongly influence the per-
formance of the device.
• Open the battery compartment at the back of the device with a screw driver.
• Insert 6 pieces of 1,5 V AA batteries. Please pay attention to the polarity. The minus
end of the battery always connects to the spring in the battery compartment.
• Close the battery compartment again.
• The device is now ready for use.
The Cat-Repellent can also be powered with a power supply. A 9 V, 100 mA power supply
can be purchased through our store (Accessory No. 60052). The power supply is connec-
ted to the power input socket
Warning! If you are using a power supply with the device, then the device may
not be installed or used outside the house.
Mounting
The device can be mounted to a wall, a tree or a fence or can be placed onto the table or
a shelf. To place it on the table, just turn it upside down. This does not have any effect
.
11