Royal Catering RCWI-4G Manual De Instrucciones página 32

• Double selection of the button will switch the system to the upper chill zone
temperature configuration.
Triple selection of the button will switch the system to the temperature
•
configuration of the lower cooling zone
f) The currently presented temperature value on the LCD display will cycle on
and off. Define the value of the desired cooling temperature using the
adjustment buttons (d, e), increasing / decreasing the value. The temperature
is adjusted in 1°C increments.
g) After defining the value of the cooling temperature, wait about 2 seconds until
the entered value on the LCD screen stabilizes. The changes will be stored in
the system memory.
h) It is possible to swap the unit's operating temperature units (F/°C). To adjust
the unit's operating temperature units, from the control panel, select and hold
the refrigeration compartment LED light button (c) for about 5 seconds.
i) The temperature unit (F/°C) of the unit's operation is displayed by the LED
indicator, on the control panel.
Function
Putting the unit into
operation
Cooling temperature
display
Upper zone temperature
control
Lower zone temperature
control
Convert temperature
units (F/°C)
MODEL RCWI-6G / RCWI-7G
a) The unit is started using the control panel, located in the upper part of the
refrigeration compartment.
b) To start the system, select and hold the unit's power switch (a) for about 5
seconds.
c) To set the value of the cooling temperature, select from the control panel the
control buttons for increasing / decreasing (d, e) the temperature value. The
temperature is adjusted in 1°C increments.
d) The currently presented temperature value on the LCD display will cycle on
and off.
Action
5 sec.
1 x
2 x
3 x
5 sec.
&
Controller
x
/
x