Publicidad
Idiomas disponibles
Idiomas disponibles
A
G
H
Figure 1: PTRS1000
A – Blade Guide
B – Adjustment Bolt
C – Grip
D – Exhaust Reflector
E – Trigger
F – Safety
G – Set Screws
H – Blade
Specifications
PTRS1000
Specifications at 90 psig (6.2 bar, 620 kPa)
Air Pressure, Working ................90 psig (620 kPa)
Free Running Speed .............................9,000 SPM
Air Consumption, Freespeed .. 2.4 CFM (15 SCFM)
Air Inlet Thread Size .......................... 1/4"–18 NPT
Air Supply Hose Size .............5/8" ID min (16 mm)
Stroke Length ................................. 3/8" (9.5 mm)
Length ...................................... ..... 8.5" (215 mm)
Weight .........................................1.57 lbs (714 g)
Max Air Supply Hose Length ................ 30' (10 m)
Noise* (Tested in accordance with ISO 15744)
Sound Pressure Level (A) .................87.2 dB
Uncertainty, K .....................................3.0 dB
Sound Power Level (A) .....................98.2 dB
Uncertainty, K .....................................3.0 dB
Vibration* (Tested in accordance with ISO 28927)
Vibration Level ..............................10.0 m/s
Uncertainty, K ................................1.49 m/s
*These declared values were obtained by laboratory
type testing with the stated standards and are not
adequate for use in risk assessments. Values
measured in individual work places may be higher.
Values and risk of harm experienced by an
individual user are unique and depend upon the
environment and manner in which the user works,
the work piece and the workstation design, as well
as upon the exposure time and the physical
condition of the user.
ZPTRS1000CE Rev. A
B
C
D
E
F
Snap-on disclaims liability for the consequences of
using the declared values, instead of values
reflecting the actual exposure determined in an
individual risk assessment in a work place situation
over which we have no control.
Applications
Snap-on PTRS1000 Air Saw is a versatile, easy to use
tool with a dual-chuck mechanism allowing the additional
use of 0.035" thick reciprocating saw blades up to 6" in
length.
The tool is designed to cut through plastic, rubber, wood,
sheet metal, and up to 1/8" mild steel. Your tool includes
an ergonomic grip, 360-degree adjustable exhaust
deflector, and a variable speed paddle style trigger.
Air Supply
Air tools operate best on clean, moisture-free, well-
lubricated air at a constant pressure of 90 psig (6.2 bar,
620 kPa) maximum.
A – Receiver Tank, Minimum 40 Gallon
(151.5 liters)
B – Compressor, Sufficient Capacity
C – Drain, Daily
D – Pipe and Fittings, Minimum 1/2"
E – Top Air Intake
F – Shut Off Valve, Easily Reached
G – Filter
H – Air Regulator, Set at Working Pressure
I – Lubricator
J – Air Tool Connection
K – Low Spot, Water Trap
L – Drain, Daily
2
Piping System
2
The piping system should be large enough to avoid an
excessive pressure drop under maximum flow
conditions. All pipe fittings and hose outlets should be
1/2" and should be arranged so there are no low spots
that collect water which cannot be drained daily. Do not
use an air hose less than 3/8" ID or one that is too long
because pressure drop under maximum flow conditions
could reduce performance.
√ Accessories are available for air tight connections.
5
Figure 2: Air Supply
(08/19)
Publicidad
