Crux ARTISAN Serie Manual De Instrucciones página 13

BREW CYCLE
IMPORTANT: For optimal brewed flavor, filtered water is preferred.
IMPORTANT: Before brewing, always check to make sure water level is past the MIN line
and add water if needed. Never exceed the MAX fill line.
NOTE: The amount of brewed coffee will always be less than the amount of water
placed into the water tank; as much as 10% is absorbed by coffee grounds and filter.
The glass carafe markings indicate the amount of water needed in the water tank to
produce the corresponding cups of brewed coffee.
1. Use the side tab to open the Coffee Maker lid.
2. Fill carafe with cold water and pour into the water tank at the back of the unit. The water level
indicator can be easily viewed inside the unit.
3. Center empty carafe on the warming plate.
4. Lower and rotate the filter holder until the filter holder handle drops down into the housing.
5. Place the gold tone coffee filter in the removable filter holder. Measure 2 level tablespoons or
1 scoop of drip or regular ground coffee for each cup of coffee desired. For stronger or milder
coffee, adjust amount of coffee to suit your taste.
6. Close the Coffee Maker lid.
7. Plug the power cord into a 120V AC electrical outlet. The default REGULAR brew strength and
"12:00 AM" will appear. The HOUR will flash as the Coffee Maker advances to CLOCK setting
mode.
NOTE: It is not necessary to set the CLOCK to brew coffee.
8. To begin brewing coffee immediately, press the BREW/OFF button. The button will illuminate
white, default TIME and REG will be displayed.
9. Perfectly temped water will shower over the coffee bed. The flavor infusion carafe lid evenly
distributes coffee throughout the brewing process to maximize the flavors and aromas of the
grounds and ensure hotter, better-tasting brews.
NOTE: To interrupt the brew process at any time, press the white illuminated BREW/OFF button.
The illuminated button and Coffee Maker will turn OFF.
10. Upon completion of the brew cycle, 3 tones will sound. The BREW/OFF button will remain
illuminated as the Coffee Maker advances to KEEP WARM, for 2 hours.
NOTE: To check the freshness of the brewed coffee while in the KEEP WARM cycle,
press and hold the PROGRAM button to confirm how much TIME has elapsed since brewing.
11. Press the white illuminated BREW/OFF button to turn the Coffee Maker OFF when the carafe
is empty or when unit is not in use.
12. At the end of the KEEP WARM cycle, 2 tones will sound, and the Coffee Maker will turn OFF.
PAUSE & SERVE
1. To serve a cup of coffee before the brew cycle is complete, slowly remove carafe
from the warming plate. Dripping will automatically cease. Return the carafe onto the warming
plate; dripping will resume.
CAUTION: To prevent injury when utilizing the Pause & Serve feature, replace carafe within
30 seconds after removing during the brewing process.
2. The flow valve is located on the bottom of the filter holder and is activated when the carafe
is removed. (See Figure 1.)
IMPORTANT: When replacing the filter holder, the flow valve must be properly inserted into the
front cavity of the machine, so that it can be seen as it sits on the top of the carafe lid.
(See Figure 1.)
11