omisa WeldControl 160 Manual De Uso página 43

O . M . I . S . A . S r l
Via Verga 9/11
20845 Sovico (MB), Italy
3.4 Technical Specifications
OMISA Weld Control 160
Electrical Specifications
Voltage
Frequency
Total rated power
Heating element rated power
Facing tool rated power
Hydraulic and control unit rated power
Power supply-side protection by breaker
Maximum length of any extension cable:
wire section 1.5 mm²
wire section 2.5 mm²
wire section 4.0 mm²
Hydraulic Specifications
Maximum operating pressure
Cylinder section
Hydraulic oil
Operating Specifications
Operating range
Ambient temperature range
Ingress protection
Memory for welding reports
Data input
Data download
Supplied reducer inserts
(also refer to Important note below)
Dimensions
Basic machine chassis
Facing tool
Heating element
Hydraulic and control unit
Carrying and storage rack
Weights
Basic machine chassis
Facing tool
Heating element
Hydraulic and control unit
Carrying and storage rack
Transport box
All reducer inserts
Using two supplied brackets fitted to their outside edge,
the distance between the third and fourth clamp of the ba-
sic machine chassis can be adjusted. Thus, Tees and elbows
can be clamped for processing them.
The referenced hydraulic oil is the product recom-
mended for the hydraulic system of the welder. If
a different brand, a different type is used, its tech-
Info
nical properties must be equivalent: HEES un-
Version November 2022_1
230 V
50 / 60 Hz
2.45 kW
0.80 kW
1.05 kW
0.60 kW
16 A (slow blow)
20 m (22 yd)
75 m (82 yd)
100 m (109 yd)
160 bar
2.94 cm²
HF-E 15
40 through 160 mm
from – 20 °C to + 60 °C
(from – 5 °F to + 140 °F)
IP 54
10,000 report
RFID transponder reader,
optionally scanner
USB A v 2.0 (480 mbit/s)
40, 50, 63, 75, 90, 110, 125,
140 mm
600 × 400 × 410 mm
430 × 330 × 80 mm
450 × 350 × 50 mm
480 × 310 × 300 mm
300 × 370 × 400 mm
34 kg
8 kg
4 kg
28 kg
4 kg
27 kg
21 kg
Weld Control 160 User's Manual
11
EN