X-LITE X-552 Manual Del Usuario página 19

- In case of malfunctioning or damage, please contact a Nolangroup authorised dealer.
- Do not remove the side mechanisms from the shell.
VISOR ( XFS-03 )
1 DISASSEMBLY
To disassemble the visor, first remove the peak, if assembled (see instructions above).
1.1 Open the visor completely.
1.2 Push the release lever of the left side mechanism downwards until its limit stop
(Fig.5) and simultaneously pull the visor away from the helmet by pushing the visor
inner pin out of the mechanism central housing (Fig.6).
1.3 Follow the previous operations on the right side of the helmet.
2 ASSEMBLY
2.1 Place the visor left side on the corresponding side mechanism by inserting the
visor inner pin into the mechanism central housing (Fig.6).
2.2 Press the visor at the side mechanism until you hear a fastening click.
2.3 Follow the previous operations on the right side of the helmet.
2.4 Close the visor completely.
WARNING
- Check that the mechanisms are working properly. Open and close the visor,
checking that the latter is held in place in its different positions by the mecha-
nisms. If necessary, follow the previous operations mentioned above.
- Do not use the helmet if the visor has not been properly assembled.
- Never remove the side mechanisms from the shell.
- Should any of the side mechanisms fail or be damaged, please contact a Nolan-
group authorised dealer.
( XFS-03 )
(Available as standard or accessory/spare part)
1 ASSEMBLY
1.1 Disassemble the visor (see instructions above).
1.2 Make sure that the inner surface of the visor is clean and check that the pin adjust-
ment external levers are turned inwards (Fig.7).
1.3 Place the PINLOCK
The silicone profile of the PINLOCK
inner surface of the visor.
1.4 Insert one side of the PINLOCK
it in position (Fig.8).
1.5 Widen the visor and fasten the other side of the PINLOCK
pin (Fig.9).
1.6 Release the visor.
1.7 Remove the protective film from the PINLOCK
entire silicone profile of the inner visor adheres to the visor.
1.8 Assemble the visor on the helmet (see instructions above).
inner visor on the visor.
®
inner visor onto one of the two visor pins and hold
®
inner visor should be in contact with the
®
inner visor and check that the
®
INSTRUCTIONS FOR USE
X-552
inner visor to the other
®
19