X-LITE X-552 Manual Del Usuario página 22

X-552
- In case of rain, the direct contact of raindrops with the scratch-resistant/fog-re-
sistant treated VPS quickly reduces sharpness of vision, thus causing scarce visi-
bility: in this case, deactivate the VPS.
- The special VPS fog-resistant treatment is usually sensitive to high temperatures
or heat sources. In this case, contaminations caused by contact with other ma-
terials might occur. These contaminations will cause marks and stains to come
out. In these cases (e.g., when the helmet is kept in the top case on hot days), it is
recommended that the VPS does not come into contact with other materials.
3 DISASSEMBLY
3.1 Open the helmet visor and lower the VPS completely (see instructions above).
3.2 Hold the left lateral part of the sunscreen and pull it towards the helmet outside
(Fig.11).
3.3 Follow the same operation on the right side of the helmet.
4 ASSEMBLY
4.1 Open the helmet visor completely and move the side slider until the limit stop (see
instructions above) (Fig.10A).
4.2 Check that the right side guide is placed downward (Fig.12); insert the sunscreen
right end into the guide until it is fully fastened to the shell housing.
4.3 Insert the sunscreen left end into the left side guide until it is fastened to the shell
housing (Fig.11).
WARNING
- Check that the VPS is properly working by activating and deactivating it (see in-
structions above). If necessary, follow the previous operations mentioned above.
- Should the VPS opening and closing mechanisms fail or be damaged, please con-
tact a Nolangroup authorised dealer.
- Do not use the helmet if the VPS has not been properly assembled.
- Since the VPS does not assure you the same protection as the one provided by
the visor, it has to be used only when the helmet visor is lowered.
REMOVABLE INNER COMFORT PADDING
The removable comfort padding consists of:
- liner
- side cheek pads (right and left)
- strap covering
All components can be completely removed and washed.
The cheek pads are also characterised by removable inner expanding foam padding.
To remove and/or assemble the comfort padding, deactivate the VPS and open the
visor completely (see instructions above).
1 DISASSEMBLING THE CHEEK PADS
1.1 Open the chin strap (see specific instructions).
1.2 Gently pull the red strap in the front area of the padding of the left cheek pad to
release the safety lever placed on its rear part (Fig.13).
22
INSTRUCTIONS FOR USE