X-LITE X-552 Manual Del Usuario página 23

1.3 Hold the front part of the padding of the left cheek pad and turn it upwards to
release the front hook and the two snap fasteners, front and top respectively,
located at its rear part (Fig.14).
1.4 Pull the rear of the padding of the left cheek pad towards the inside of the helmet
to release the rear snap fastener placed on its rear part (Fig.15).
1.5 Remove the rear tab of the comfort padding of the left cheek pad from the cavity
between the rear trim and the polystyrene inner shell; then completely remove the
cheek padding from the helmet (Fig.16).
1.6 Follow these operations with the right cheek pad padding.
Do not remove the polystyrene cheek pads from the helmet shell.
2 DISASSEMBLING THE INNER EXPANDING FOAM PADDING OF THE CHEEK
PADS
To facilitate the washing of the inner comfort padding components, the cheek pads of
the helmet are equipped with inner expanding foam padding that can be removed from
the fabric lining. To remove the padding, proceed as follows after disassembling the
cheek pads from the helmet (see instructions above).
2.1 Slightly remove the inner expanding foam padding from the fabric lining of the left
cheek pad (Fig.17).
2.2 Follow these operations with the right cheek pad padding.
Warning: once the expanding foam inner paddings have been removed from the
cheek pads, make sure that the rear snap button "D", the front and top snap
buttons "C", the hook "A" and the NERS safety lever "B" are properly fastened to
the rear frame of the fabric lining of the cheek pads (Fig.18); otherwise place them
again appropriately.
3 DISASSEMBLING THE CHIN STRAP COVERING
To remove the chin strap covering from the strap, proceed as follows after removing the
cheek pads from the helmet (see instructions above).
3.1 Pull the left strap covering at the "hook and loop fastener" to separate it from the
chin strap and then remove it (Fig.19A).
3.2 Follow these operations with the right strap covering.
4 DISASSEMBLING THE LINER
4.1 Release the left rear tab of the liner from the shell rear edge by slightly pulling the
comfort padding inwards (Fig.20). Then follow the same operation with right rear tab.
4.2 Remove the adjustment tab from the rear cavity between the outer shell and the
polystyrene inner shell.
4.3 Pull the comfort padding rear towards the inside of the helmet to release the two
side buttons located at its rear from their housings on the rear support, which is
fixed to the polystyrene inner shell (Fig.21).
4.4 Hold the liner left front and pull it upwards in order to remove the corresponding
liner tab from the support fixed to the polystyrene inner shell (Fig.22). Then follow
the operation with central front and right tabs.
4.5 Completely remove the comfort padding from the helmet.
INSTRUCTIONS FOR USE
X-552
23