GYS ARCPULL 200 Manual De Instrucciones página 38

Operating manual
7.1.1. TYPE OF WORKPIECE TO BE WELDED
From the synergy displayed on the screen, defined by a part type (3), its material (1) and its protection (2), it is only possible to
change the size of the part (M4, M5, etc.) by pressing G+ and G- without having to go through the setup menu (see § 7.4.1).
Insert Pictograms
Pull ring
Stud
Insulation nail
7.1.2. THICKNESS OF THE SUPPORT PLATE
Thickness displayed in millimetres.
To increase or decrease the thickness of the sheet on which the insert will be welded, press the D+ and D- keys.
The thickness ranges that can be selected are dependent on the type, size, and material of the part to be
welded.
If the thickness of the sheet metal is less than that shown on the display, the sheet may be distorted at the welding point.
When the display shows
If this symbol does not appear, then the maximum sheet metal thickness has been reached. Over this thickness, the welding of the
insert is no longer guaranteed.
Note : When switching from Synergic to Manual mode, all welding parameters (current, time, height, etc.) associated with that
synergy are transferred to manual mode. This makes it possible to fine-tune the machine settings if the selected synergy does not
achieve the expected result (welding with too much, or not enough, energy).
7.2. WELDING IN MANUAL MODE
In Manual Mode the time, current, the lift height for the insert and the activation of the digital spring are user-defined.
The main Manual Mode screen displays:
1 — The arc time in milliseconds (see § 3)
2 — The arc current (see § 3)
3 — A message field specifying the status of the product (see § 7.3)
38
Translation of the original
instructions
Comments
Pressing the G+ and G- keys will scroll
through all the ring synergies
contained in the unit. The material (1) and
gas protection (2) are updated automati-
cally.
M6
Synergies associated with studs
, the sheet thickness is sufficient and the welding parameters of the synergy are no longer affected.
t
ms
1
100
Photo
I
A
200
message
area
3
ARCPULL 200
2