Technical Description; Connecting The Inverter; Fastening The Inverter - Waeco PerfectPower PP152 Instrucciones De Montaje Y De Uso

PerfectPower
5

Technical description

The PerfectPower inverter can be operated wherever there is a 12 V DC
vehicle socket (for PP152, PP402, PP602) and a 24 V DC vehicle socket (for
PP154, PP404, PP604). The device is additionally cooled with a load and
temperature dependent fan.
The maximum constant output for the devices is as follows:
For PP152 and PP154 inverters 150 W
For PP402 and PP404 inverters 350 W
For PP602 and PP604 inverters 550 W
Never connect devices that have a higher power requirement.
The inverter is equipped with protection against thermal and electrical over-
loading, as well as excess and insufficient voltage. The inverter switches off:
If its internal temperature is too high
If the load exceed the values stated above
If the input voltage is too high or too low
The inverter can be switched on and off using the switch directly on the
device or using an external switch.
Note
I
Note when connecting devices with an electrical drive (such as
power drills and refrigerators), that they often need more power
than is stated on the type plate.
6

Connecting the inverter

Caution!
a
The cable between the battery and the inverter may not exceed a
maximum length of 2 m.
6.1

Fastening the inverter

You can fasten the inverter using the four holders supplied.
When selecting the installation location, observe the following instructions:
The inverter can be mounted horizontally or vertically.
The inverter must be installed in a place that is protected from moisture.
Technical description
23