Rectifying Faults; Guarantee - Waeco PerfectPower PP152 Instrucciones De Montaje Y De Uso

PerfectPower
10

Rectifying faults

Fault
No output voltage
No output voltage
No output voltage
No output voltage
The device switches on and
off repeatedly
The inverter switches off
when the consumer is
switched on
The output voltage is too
low.
11

Guarantee

The statutory warranty period applies. If the product is defective, please
contact the manufacturer's branch in your country (see the back of the
instruction manual for the addresses) or your retailer.
For repair and guarantee processing, please include the following docu-
ments when you send in the device:
A copy of the receipt with purchasing date
A reason for the claim or description of the fault
Cause
No contact to the battery
Overheating
Defective fuse (in the inverter
or the vehicle)
Device defective
Excessive constant load
Starting current too high
Batter voltage below 10.8 V
(PP152/PP402/PP602) or
21,5 V (PP154/PP404/PP604)
Rectifying faults
Remedy
Check contact and cable.
Switch on the ignition if
necessary.
PP152/PP154: If necessary
check and replace the 12 V
and 24 V vehicle socket.
Switch off power consuming
devices.
Let the inverter cool down
and ensure better ventilation.
Replace the the fuse with one
of the same specifications.
Replace the device.
Reduce the load.
Compare the device power
with the maximum power of
the inverter.
Charge the battery (start the
engine).
27