CARE FITNESS Spider Pro XT Manual De Instrucciones página 22

12 hour or 24 hour mode. Press the MODE button to set your choice and advance to the
hours setting.
STEP 3: The hours will flash. Press the SET button (or press and hold) to advance the hours.
Press the MODE button to set the value and advance to the minutes setting.
STEP 4: The minutes will flash. Press the SET button (or press and hold) to advance the minutes.
Press the MODE button to set the value and advance to the seconds setting.
STEP 5: The seconds will flash. Press the SET button to reset the seconds to "00".
STEP 6: Press and hold the MODE button to exit the clock set-up screen and return to the Clock
display screen.
DETERMINING WHEEL SIZE
uses wheel circumference to calculate speed and distance. There are three methods for determining wheel
circumference:
Measure wheel diameter (more accurate)
Measure: Measure your wheel diameter in millimeters (1 inch = 25.4mm) and multiply by 3.1416. Enter this value in
the computer (see "Programming Wheel Size").
PROGRAMMING WHEEL SIZE & SELECTING MILES OR KILOMETERS
After determining wheel size, enter the value in the computer.
STEP 1: Press the MODE button to advance to the Odometer
and hold the SET button for 2 seconds to enter the wheel size setting screen.
STEP 2: "KM/H" or "M/H" will flash. Press the SET button to select the desired speed scale (mph
or kmh) and then press the MODE button to set your choice and advance to the wheel
size setting.
STEP 3: The digit on the left side of the screen will flash. Press the SET button to adjust the
value. Press the MODE button to set the value and advance to the next flashing digit.
STEP 4: Repeat this sequence until all digits have been set to the appropriate value.
STEP 5: Press and hold the MODE button to set the wheel size in memory and return to the
Odometer display screen.
STEP 6: To program a second wheel size (if you plan to use the CY-200W on two bikes with
different wheel sizes), depress the blue button on the back of the computer to activate
the second wheel size. Then follow steps 1 through 5 to program the wheel size.
INSTALLATION
Wireless transmission makes installation simple. Begin by attaching the computer bracket to the handlebar.
STEP 1: Use the included zip-ties and shim pad (if necessary) to attach the bracket to the
handlebar. Tighten the zip-ties securely and trim off any excess length.
STEP 2: Attach the computer head to the bracket. Press the computer head into the bracket and
rotate it clockwise to lock in place. See Figure 3. You should hear a "CLICK" when the
computer is locked in place.
) display screen. Press
(ODO
10