CARE FITNESS Spider Pro XT Manual De Instrucciones página 23

STEP 3:. Adjust the position of the magnet by sliding both pieces up or
down to achieve 1-5mm of clearance between the two. If the magnet and sensor are not
close enough, the computer will not pick up a reading or the reading will be inconsistent
and erratic. Most problems that occur when installing a new computer are related to
magnet and sensor alignment and spacing.
STEP 4:. Pick up the front end of the bicycle and spin the front
wheel. The computer should register a speed reading within 1-2 seconds. If not, check
the alignment of the wheel magnet and sensor, and make sure that the space between
the magnet and sensor is 5mm or less. Adjust as necessary and re-test.
PLA SCREENS
RESET DISPLAY SCREENS
All display screens (except Odometer) are reset simultaneously. Advance to the Auto Ride Timer (
Press and hold the SET button for three seconds to reset all display screens to zero.
To reset all display screens including Odometer (
(including gender, weight, clock and wheel size) you must remove the battery from the computer head. See "Battery
Installation."
MAINTENANCE
Computer
If you notice a change in the display screen contrast, or the figures become faint, it may be time to replace the
computer battery. See "Battery Installation". We recommend replacing the computer head and fork sensor batteries at
the same time.
Fork Sensor
Periodically check the alignment of the wheel magnet and fork sensor and make sure that the space between the
magnet and sensor is 5mm or less. Remove any signs of rust or corrosion from the magnet to ensure proper function.
Cleaning
The fork sensor, wheel magnet and handlebar bracket can all be cleaned with mild soap and water. Do not use harsh
abrasives or petroleum based cleaners to clean any of the components.
Low Battery Indicator
When the computer head or fork sensor batteries are low, the low battery icon will appear in the display screen. Make
a note of any data you wish to record (such as odometer reading or wheel size settings) before replacing the batteries.
BATTERY INSTALLATION
Low Battery Indicator
When the computer head or fork sensor batteries are low, the low battery icon will appear in the display screen. Make
a note of any data you wish to record (such as odometer reading or wheel size settings) before replacing the batteries.
3. Computer Head: Insert a coin in the battery cover slot on the back side of the computer head and twist
counterclockwise to remove. Remove the old battery and dispose of properly. Install a new CR2032 battery with the
positive (+) pole facing up. Replace the cover and turn clockwise to tighten.
) AND reset all programmed settings
ODO
11
) display screen.
ATM