Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
DC motor
Programmable
Silent
Oscillating mode
Round base
Touch control
24 speeds
INSTALLATION
Before using the appliance, remove all
packaging and inspect the appliance for
any damage. If there is any damage on the
product, please take the unit back to the
store where you bought this appliance.
• The fan is packaged with the grill
disassembled. You must assemble the
grills before operating the fan.
• Never operate the fan without its base
and other parts.
• Operate the fan only in vertical position;
any other position may be dangerous
for the user.
• Assemble the base and other parts of
the appliance considering the following
notes.
• If the appliance is to be used as a 130 cm
high standing fan
• Unpack the fan and remove all parts of
the package.
• Insert the lower tube (16) into the hole
in the base (17), place the washer (18)
under the base and tighten the base
with the L-screw (19) clockwise.
• Insert the intermediate tube (14) into the
center of the lower tube (16), align the
screw in the screw holes and tighten
both tubes with the screw provided (15).
• Insert the fan head together with the
upper tube (10) into the centre of the
intermediate tube (14) and align the
screw hole, screw and tighten with the
screw provided (12).
14
Equipped with
efficient
and
quiet motors
yes
yes
yes
yes
yes
yes
• Use the fixing nut (6) to attach the rear
grille (7) to the fan head (9). Then use
the blade retaining nut (4) to secure the
fan blade (5).
• To place the front grille on the rear
grille, you must use the grille ring to
keep both parts together. Tighten the
ring with the screw provided once the
grilles are properly positioned.
• If the appliance is to be used as a 90 cm
stand fan
If the fan is to be used as a 90 cm high
foot fan, remove parts 12 and 14 from the
assembly. If the appliance is to be used as
a table-top fan. If the fan is to be used as a
table-top fan, remove parts 12, 14, 15 and 16
from the assembly.
HOW TO USE IT
Before using the fan, make sure it is on a
flat, stable surface. Damage may occur if
the fan is placed on a slope.
NOTE: Before inserting
the plug into a power
outlet, make sure that the
voltage corresponds to
the one indicated on the product
label, and that the plug has a
ground connection.
Using the control panel on the fan:
1. Press "ON/OFF" on the control panel
to turn the fan on. Press the speed
button to select the desired speed,
considering this fan has 24 speeds.
The display will show the selected
speed. To change speed, please press
again for 3 seconds and the speed will
change automatically.
2. Press the "SWING" button to allow
oscillation from right to left. Pressing
again will stop the oscillation.
3. Setting the timer: Press and hold the
"SWING" button for 3 seconds and the
display will flash. Press the 'SWING'
Publicidad
