Descargar Imprimir esta página

Tognana Avantspace D2DTU01AVSP Manual De Instrucciones página 19

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 46
ASSEMBLING THE FOOD BLENDER
1. Place the bowl on a flat and stable surface.
2. Carefully lift the blade unit, holding it by the central plastic shaft then insert it, after
removing the protections, on the metal pin on the bottom of the bowl and secure it (you will
hear a click).
3. Position the processing lid on the glass bowl, aligning the corresponding upside down U-
shaped slots and press on it to fix it in position.
4. Position the motor unit aligning the pins on the processing lid with the respective slots in the
motor unit. The motor unit must be perfectly adapted to the lid without any gaps, otherwise
the appliance will not work.
OPERATING PRINCIPLE
Caution: Do not operate the appliance if the bowl is empty!
1. Position the blending blade or ripple disc blade on the metal pin on the bottom of the bowl.
2. Insert the food to be blended in the bowl. Do not overly fill the bowl, considering that the
foods should not exceed 2/3 of the bowl's volume at the end of processing.
3. Position the processing lid and motor unit on the bowl. The lights will flash for a moment to
indicate that the appliance is ready for use.
4. Press the speed button I (low) or II (high) located on the top part of the motor housing.
5. Allow the food blender to work during processing. Do not shake or move the food blender
during processing.
6. At the end of the processing cycle, release the speed button selected and the appliance will
stop.
7. Check that the blade or the disc are completely stopped before removing the motor unit and
processing lid.
8.
Remove the disc or the blades by firmly grabbing the shaft and lifting it.
blades are sharp!
9. Once the blades or the disc have been removed, the ingredients can be removed from the
bowl.
If food builds up around the blades during use:
1. Release the speed button and wait for the blades to completely stop.
2. Remove the motor unit and processing lid.
3. Use a spatula to carefully remove the food. Do not use your fingers because the blades are
sharp!
4. Once the food has been removed and the blades cleaned, refit the processing lid and motor
unit and continue with use.
TIPS FOR USE
Start processing with an impulse movement, by pressing and releasing the speed button
quickly, until the desired consistency is reached.
Do not use the food blender for more than 1 minute continuously. After 1 minutes of
continuous use, the appliance may overheat. Leave the appliance to rest for at least 5
minutes before using it again. After 3 cycles, the appliance must be stopped for 15 minutes
to allow the main motor to cool down.
To avoid damaging the blades, the first 3 seconds of speed I will be at maximum speed,
and then slow down.
Do not use to mix very hard dry foods such as meat with bones,
soybeans, pepper, coffee beans, ice cubes and frozen food.
CAUTION, the
17

Publicidad

loading