Balluff BAE SA-FF-055-RS Manual De Instrucciones página 8

Signal converter for screw-in flow controllers
BAE SA-FF-055-RS
Safety notes
Installation and startup may only be performed by
trained specialists with basic electrical knowledge.
Qualified personnel are persons whose technical
training, knowledge and experience as well as knowledge
of the relevant regulations allows him to assess the work
assigned to him, recognize possible hazards and take
appropriate safety measures.
The operator is responsible for ensuring that local safety
regulations are observed. In particular, the operator must
take steps to ensure that a defect in the measuring system
will not result in hazards to persons or equipment.
If defects and unresolvable faults occur in the signal
converter, take it out of service and secure against
unauthorized use.
General safety notes
Turn off power to the system before connecting the signal
converter.
Always observe the safety instructions in this guide and the
measures described to avoid hazards.
Electrical connections
Fig. 3: Wiring diagram
2 english
Display and operating elements
Potentiometer
Fig. 2: Display and operating elements
Element
Green LED On when the set limit value is exceeded.
Yellow LED On when the set limit value is reached.
Red LED On when the set limit value is undershot.
Potentiometer Setting the limit:
– Turning clockwise results in a lower
limit value.
– Turning counter-clockwise results in a
higher limit value.
Terminal
Sensor with switching output
(see Fig. 2)
1
2
Connection to flow controller
BFF T_ _ _ _-_ _002-_ _ _A0A-S4
3
4
5
6
7
8
4 × green LED
Yellow LED, relay
Red LED
Function
Relay NO
Supply +
Supply –